[myke]

Re: tecnik tkl9060

Hi thanks for the rapid responce 😀 the machine is built in will endeaver to remove it and relay the details from the plate to you in the near future.

ps excelent forum

[myke]

Re: Smeg CR330SE fridge-freezer defrost drain blocked

hi i use a large syringe and some plastic tube to unblock the drains if its mouldy i ad a small amout of bicarbonate of soda to help keep it clear.
hope this helps

[myke]

Re: candy go 1482

http://www.ukwhitegoods.co.uk/modules.p … =Help_Desk

But make sure you have checked all other options as mentioned earlier exspecially the motor the card was my last option

[myke]

Re: candy go 1482

Hi Guys

fitted a new pcb and machine runs fine thanks again for your help.

😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀 😀

[myke]

Re: candy go 1482

thanks will check the pump for partial blockage and resistance

already done an insulation test on drum motor with a 500v megger it was practically infinity (disconected plug from back of motor to do this so as not to damage pcb

will keep you informed

thanks for the input the scenario fits perfect

[myke]

Re: Smeg DI612 Error Code 2

hi i had cleaned the dishwasher tubes etc. the problem occured haphazzard at first but eventually became permanent this solution has worked fine for 10 weeks or so now and must be an easy fix for the layman who is not technically minded thanks for the heads up penguin45 (ie the link to the fill matrix) i will know what to call it next time lol will keep you posted if i have any problems but it seems fine its used twice a day most days

[myke]

Re: Smeg DI612 Error Code 2

hi had the same problem found an easy fix this may work for you ? takes 2 mins try turning the water inlet tap (this tap is the tap you turn off to stop water going into your machine) so that the water enters the machine at a slower rate this worked for me but i found this out the hard way after stripping the side off the machine and watching water go through a sophisticated fill loop(looked like a printed circuit but is white and fills with water one hell of a level switch!) seems this is a timed fill and if the water enters too fast it trips on overfill hope this helps you 😀

[myke]

Re: diplomat8132 intermitant fault

hi above post was me dunno why it says guest prehaps i forgot to log in

[myke]

Re: diplomat8132 intermitant fault

not working at all today wont do a cold rinse so i guess that rules out the heater and stat never realy looked but how much water should be in the machine when full1/2″ or more? managed to get an instruction book from a friend at mfi it says 2 and 5 are indeed an E2 error safety level switch tripped
this water level switch is it a similar type to a washing machine ie a presure switch or is it a float switch? machine is intergrated and i have checked its level
thanks for the speedy replies guys myke

[Author]

Posts