Forum Replies Created
-
Posts
-
Re: Bosch door interlock prob
Martin wrote: elaborate on what the hell a Metaflex is?
A manufacturer of interlocks, especially exploding red ones beloved of Hotpoint.
Chris.
Re: Blomberg interlock
It’s a Brandt built machine, so Dave might be able to scare up some info.
Chris.
Re: Indesit DG6145 overfills sometimes
Pike wrote:And go and by a Proline from comet
Which is actually made by…………………… Indesit.
Penguin45.
Re: Creda Reversair Sensadry – tripping out RCB
I’d start with the mains suppressor where the cable joins the machine. However, you will need a suitable test meter and the skill to use it safely and correctly to make a correct diagnosis.
If you can’t do this, please get some pro help. Check repairs@ or Directories for a UKW engineer in your area.
Power off if you continue to investigate.
Regards,
Penguin45.Re: HELP! Indesit W123S continually fills with hot water
Well, it ain’t the finest washer ever built. If it’s in a muti share student house (5? 6?) it verges on cruelty……. (no disrespect to daughter implied).
You need to consider a budget of £300-350 for a robust appliance. Zanussi, Whirlpool and Gorenje are all adequate, personally I think that Bosch is a bit better – 2 year guarantee is nice.
Or, go mad and buy a Miele – daughter will inherit it in the distant future.
Regards,
Penguin45.Re: mutlimeters/tester
leavemetogetonwithit wrote:Is it a Fluke?
Sounds quite deliberate to me……….
😆 😆
Chris.Re: Ariston AWD12 Dial spins…
Count the flashes from the power light – ie 1,2,3,4 pause, repeat and report back. It’s a code.
Regards,
Penguin45.Re: 5 year old Zanussi Jetsystem Excel (turbodry) leaking.
Door seal is 1242635-08/2, SSP £19.90 + VAT. We are unable to comment on the overall pricing as labour rates vary across the country. I would comment that I can fit this door gasket through the door opening in 30-40 minutes, allowing for time halfway to let my hands recover from cramp. Pulling out the tank is a long way of doing the job!
Regards,
Penguin45.Re: HELP! Indesit W123S continually fills with hot water
If the hot valve is continuously filling when the power is on it will be due to a transistor failure on the computer board. Part number is C00090981 and will need the eeprom transfering across from your old board. You should seriously consider a professional repair due to the complexity of the repair.
Regards,
Penguin45.Re: Creda 37747 Condenser dryer
