[qprfcmark]

Re: Bosch Exxcel SGS45E02GB – Water overflowing base on star

Dave,

Thanks for your help. Bosch repaired it under the recall. Now working fine.

Regards

Mark

[qprfcmark]

Re: Bosch Exxcel SGS45E02GB – Water overflowing base on star

Hi Dave,

Thanks for your reply.

Model number SGS45E02GB/45 is definitely covered by the recall.

When you say “its a mod in the timer and you fault will prob be related” how would they be related?

Regards

Mark

[qprfcmark]

Re: Panasonic NN-A554W Microwave stops during microwaving.

Thanks for the reply electrofix.

Replaced Magnetron and now working fine. The unit does not have a capacitor, therefore was quite safe to work on once unpluged. Only an idiot would work on an inverter supplying 5000v to the magnetron whilst the unit was switched on! :rolls:

[qprfcmark]

Re: Whirlpool ARC4170 Fridge Freezer alarm constantly soundi

Sent the circuit board for repair to http://qer.biz/
. Capacitors & relays either not working or transmitting too low a voltage for the compressor to run. All working now for the total cost of £43.20! Circuit board had a 1 day turnaround!! 😀

[qprfcmark]

Re: Whirlpool ARC4170 Fridge Freezer alarm constantly soundi

fridge-freezer-forum/whirlpool-american-fridge-freezer-broken-down-help-t6816-15.html

by dufferuk » Tue Mar 07, 2006 12:48 am

“Over time it appears that the capacitor that makes up part of the firing circuit to the Compressor relay fails. There are four relays on board, three black, one orange (its the orange one that we are interested in as this enables the compressor). The relays are enabled from the microprocessor on the board via a triac controlling the switching of live onto a diode bridge and through a resistor and capacitor on the neutral side. Over a period of time the capacitor will break down and won’t be able to hold enough energy to fire the relay enabling the cooling via the compressor.”

********************************

After much searching looks like the above is the problem. May be more than one capacitor has given up on the rear PCB. I will be sending it to be checked by these guys unless someone knows where I can buy a new one at a resonable price?………..

http://www.ebay.co.uk/itm/110993059366? … 1438.l2649

[qprfcmark]

Re: Bosch Classixx 1200 – Fills with water and then stops.

qprfcmark wrote:Penguin45……….Do you have any step by step instructions / diagrams on how to remove the motor on this model? Thanks

Just worked it out…………..

1: Tilt machine to access underneath of machine.
2: Remove earth cable and live connections from motor.
3: Stand machine upright and remove rear panel at back of machine by undoing screw at bottom of panel.
4: Remove drive belt from motor via removed rear panel.
5: Remove 2 retaining bolts holding motor in place via rear panel.
6: Pull motor towards rear panel and motor will fall out of place.
7: Remove 4 long screws holding motor together.
8: Remove Carbon Brushes and replace.
9: Assemble in reverse.

Regards

Mark

[qprfcmark]

Re: Bosch Classixx 1200 – Fills with water and then stops.

Penguin45……….Do you have any step by step instructions / diagrams on how to remove the motor on this model? Thanks

[qprfcmark]

Re: Bosch Classixx 1200 – Fills with water and then stops.

Thank you Penguin45 for the quick response and links! Will let you know outcome!

[Author]

Posts