Forum Replies Created
-
Posts
-
Re: Hotpoint WT540
Specialist01269 wrote:Glad to hear it, what was the colour code on the valves after?
On the WT540, check the motor connector is seated properly, check motor brushes, check for breaks in the motor harness.I checked all of that i think the main PCB in down.
Re: Hotpoint WT540
I am an electrician by trade
Myself and a few frends run a l scrap yard. we try to repair the appainaces that come to us.
Then we sell them to local second hand shops.
So yes we are tradingRe: Hotpoint WT540
I checked the motor brushes they are fine
Whatever I select the door lock light never comes on even though the door locks .
it will not pump water out
it will not take water in
the drum will not turnRe: Indesit WD12S Washer-Dryer
The wires going to the valves should it be the nearest one to the case get the white pair the second one in gets the black pair and the thrid one which is a blue valve get the blue pair
Re: Indesit WD12S Washer-Dryer
Could anyone tell me why it has three valves on the back when it only has one inlet hose?
Thanks
Specialist01269Re: Indesit WD12S Washer-Dryer
I have given the wrong model number, The model number is WIDL126
I notice its not taking in any water on the rinse cycle.
I meter out the three inlet valves two had continuity and one was open circuit.
So am i right in thinking it the valve?Re: Indesit WD12S Washer-Dryer
I checked the element which is fine also how do i check the thermostat ?
I connected my meter to the thermostat which had no continuity, but when i dripped the thermostat into hot water i seen the resistance read lower and lower on my meter.
is the thermostat working?
