[rickard]

many thanks Dave will change pressure switch

[rickard]

Morning Dave Thanks for your reply. No the test program wont work either and no damage to the board just completely dead after the start beep. I have quoted for a new board

[rickard]

Thanks for the info Dave. No breaks in the door wires just beeps to start then nothing. No pump as you would expect

Andy

[rickard]

I have one of these which beeps when you close the door and registers a program but nothing starts I have checked all componants but they seem all ok. Any help would be much appreciated

[rickard]

Thanks Dave Much appreciated

[rickard]

Thanks Dave. I didn’t suspect that as no noise from motor after first fill

[rickard]

Thanks Dave. Seeing as I have changed the ntc and made sure there is no blockages I can only assume a faulty PCB. Many thanks for your advise. Andy

[rickard]

Hi Dave. lights 1,3 and 4 are illuminated counting up. Thanks

[rickard]

Hi Dave. Thanks for the quick response, yes checked all heaters and all fine. The appliance goes through a wash fine with no problems it just stays on 1 minute

Andy

[rickard]

Thanks Dave much appreciated looks like the only place with stock is Indesit themselves

[rickard]

Thanks Dave I will ask availability as that states going obsolete soon
Andy

[rickard]

This one has got the motor in the middle and no way of getting in to the motor or pipes.

[rickard]

Many Thanks Murv

PM sent

[rickard]

Thanks Murv

Thats also out of stock so if i can buy a used one from you that would be great

Andy

[rickard]

Fantastic thank you for such a quick reply.

Andy

[Author]

Posts