Forum Replies Created
-
AuthorPosts
-
superfix
ParticipantRe: Bosch WTE84103GB/08
The water isn’t getting upto the drawer… after 2 mins the flood s/w will bring the light on.
Blockage in pump, hose or plastic piece that fastens to the drawer.
superfix
ParticipantRe: neff drier R4380X0eu/04
Have you removed the bearing and checked ??
Cos my info shows a carbon pickup on the bearing too.
superfix
ParticipantRe: neff drier R4380X0eu/04
In that case, whats the state of the carbon pick up on the bearing like ??.
superfix
ParticipantRe: neff drier R4380X0eu/04
Even though the plugs are coded, there is one which can be put on in the wrong place.
The result is exactly as you describe…. I know cos I’ve done it myself !!
superfix
ParticipantRe: Your opinions on a small claim….
dont agree, given what he has gone through !50 is not too much. Sure BSH would have been higher and also probably insisted on the appliance being removed first.
BSH would’ve charged £85 + part they wouldn’t insist on it being removed unless it was a seriously bad install.
Personally I’d take the cash they’re offering.
superfix
ParticipantRe: NEFF dishwasher S5453X1GB-50 module-control
First thing is…. if it’s blown triacs, then there’s a real possibility that the new one may also go bang.
You need to find out what the triac is switching
If it needs coding there will be instructions with the new pcb.
superfix
ParticipantRe: Bosch Dishwasher SGS43A12GB/12
Nice one Scots, glad you got it sorted :tup: first time for everything eh.
Lee, I’m not gonna get involved with you… as you seem to know everything.
Merry Crimbo everyone.
superfix
ParticipantRe: Bosch Dishwasher SGS43A12GB/12
Lee, you can be a right ar$ey get.
In 11 years of working for BSH I have NEVER had an NTC fault, of course they may go faulty, buth there are other things that are far more common to check first.
Has the OP checked the pressure chamber and sump hose as Nomad Paul suggested ?.
Those two are by far and away the most common fault for no heat.
superfix
ParticipantRe: Bosch Dishwasher SGS43A12GB/12
Why bother with the test prog…. just stick it on a quickwash, the heater should come on a couple of minutes after it stops filling.
Never had an NTC fault yet.
superfix
ParticipantRe: Bosch WAE24162GB not spinning
What did you have in it ?
superfix
ParticipantRe: Bosch Logixx SGS66A02/GB20 low water level
Check continuity of dump valve on the bottom of the side chamber as these can go.
superfix
ParticipantRe: Siemens Siwamat 5401 – cleaning the condenser
Run the condenser cleaning program after EVERY dry cycle 😉
superfix
ParticipantRe: bosch wfo2864gb/01
Doesn’t that mean “what bollox”
superfix
ParticipantRe: Bosch Dishwasher intergrated
problem is the spacers between the facia and the furniture door
Never seen any spacers on any in 11 years 😕
superfix
ParticipantRe: F$&*ing computers..
Cheers guys
The missus took it into work and got the IT geeks that work for her to sort it 8)
I asked her what they did, but her answer was “dunno, but it works now” 😀
-
AuthorPosts
