Forum Replies Created
-
Posts
-
Re: bosch
raw wrote:very easy strip knock bearings out fit new ones rebuild half hour job sorted 😀
You’re havin a laff.. It’s a tank out and split it job
Re: bosch wvti28409a
NTC will cure it… so long as harness and connections are ok. BTW it’s a Smeg dressed up
Re: Bosch sealed drum WAA24270
iadom wrote:Perhaps I should rephrase my question, :rolls: I have not done any repairs on these.
Does that small thing that looks like a filter just screw out. ❓
yep
Re: bosch wtb7655 dryer
More ducts, hoses and stats than you can shake a stick at plus a seperate heater box with built-in NTC…blimey. It’s just got to be a Gorenje? Sad
You ‘aving a laff…
Re: Bosch Ceramic Hob PKE611E14E Wiring!
If you can’t read that wiring diagram, I would strongly recommend you call somebody that can.
Re: You want to charge me HOW MUCH!
Fitted a door boot to a Siemens integrated washer today. After I’d finished, during conversation she said that was cheaper that the other guy quoted me over the phone.
I asked her “how much” apparently he said £200, when she said it was integrated, he replied “in that case you’re looking at £250” 😯
Re: Bosch WTL6508GB/07 8504200860 Condenser Dryer Leaking
After two minutes of float s/w being made, m/c cuts heater off therefore no more condensed water.
Re: Neff Dishwasher S54M45X5GB/01 Water Heater
Not really a DIY job I’m affraid. Major and complete strip down of the m/c is required to replace the heater.
Even engineers have been known to run from this job 😉
Re: Siemens Hydro sensor, usual problem, no idea what to do
Have you got good ciculating pressure ?.
There is a safety s/w on the heater, if the pressure is too low to make the s/w, then you’ll get no heat. Obviously, check the s/w is making and breaking. If it is, it’s possible there is something obstructing the circ pump.
Another possibilty is that the stat/NTC on the top of the heater box is faulty.
Power off please if you’re going in :zap:
