Forum Replies Created
-
Posts
-
Just wanted to update, found the cause of the blown tracks and transistor, there was a electrical leak on the thermoactuator probably due to water getting into it but not sure, replaced and all works fine, thanks to all for the help.
Thanks Dave, that would be great, please send to mgrosstv@gmail.com
Just giving an update, re-checked the wires at the bottom of the door and all ok also traced the wire back from the triac and it goes to the fan and also checks ok. I had previously changed the ntc for the water temperature as the water was just warm and the problem started after that but probably a coincidence.
That would make sense as the panel blew on the drying part of the cycle, I have checked the wiring at the bottom of the door and all appears ok but I will double check also check the fan, cabling to it etc
I dont think they go dimmer but will check, manual would be great, my email is mgrosstv@gmail.com. Many thanks.
Thanks for your reply, I thought this was a overheat error so did not consider the heater, will check, Thanks
Re: ZDE47100W Start light flashes red
Taken PCB out and checked for dry joints or bad connections but all ok, caps look ok re-assembled and working ok at the moment. Will update any changes. Thanks
Re: Bosch dishwasher module
Thanks for your reply, I assumed that it was needing re-coding so thanks for the info, the origional problem was the heater relay dry joint problem which I re soldered but still would not go through the cycle so maybe there is another fault.
