telemek

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 43 total)
  • Author
    Posts
  • in reply to: Beko WMB91442LW shows end #445202
    telemek
    Participant

    Re: Beko WMB91442LW shows end

    Thanks for your reply, looks like it may be new machine.

    in reply to: Hotpoint WT721 Display & lights flickering #427602
    telemek
    Participant

    Re: Hotpoint WT721 Display & lights flickering

    Capacitor on power pcb replaced (680uf), all ok now, many thanks. 😀

    in reply to: Hotpoint WT721 Display & lights flickering #427601
    telemek
    Participant

    Re: Hotpoint WT721 Display & lights flickering

    I will check power board & will post result, Thanks

    in reply to: Miele W5748 washing machine cuts out #421899
    telemek
    Participant

    Re: Miele W5748 washing machine cuts out

    Thanks for your reply, will check and post result.

    in reply to: LG Fridge/freezer lights #421045
    telemek
    Participant

    Re: LG Fridge/freezer lights

    Thanks for info Bob, I thought that was how it is done but didnt want to cause damage.
    Thanks again.

    in reply to: Bosch SRV43A23 Dishwasher No heat #412461
    telemek
    Participant

    Re: Bosch SRV43A23 Dishwasher No heat

    As it’s built in I have yet to get into it properly but that is going to have to be next step, will post result.

    in reply to: Bosch SRV43A23 Dishwasher No heat #412459
    telemek
    Participant

    Re: Bosch SRV43A23 Dishwasher No heat

    Already done that, could this be thermostat s/c?

    in reply to: Miele G640 dishwasher leak #407774
    telemek
    Participant

    Re: Miele G640 dishwasher leak

    Very grateful for your diagram, I can see what I left out, should have taken a note but did not expect to be as long re-assembling.
    Many thanks.

    in reply to: Miele G640 dishwasher leak #407772
    telemek
    Participant

    Re: Miele G640 dishwasher leak

    Did not think Miele would give any info if no trade account but will give it a go. Thanks

    in reply to: Bosch WBB24759 washing machine #403232
    telemek
    Participant

    Re: Bosch WBB24759 washing machine

    Done that and getting readings on all 5 pins (2 for tacho reading quite high resistance)

    in reply to: Bosch WBB24759 washing machine #403230
    telemek
    Participant

    Re: Bosch WBB24759 washing machine

    No, motor still not turning, checked heater element shows ok with no leak to earth but never checked the pressure switch etc so will check that & post update.

    in reply to: Neff K9524X6 Fridge/freezer #391964
    telemek
    Participant

    Re: Neff K9524X6 Fridge/freezer

    Changed control PCB in top of fridge, all working fine.

    in reply to: BHWM129 flashing lights #389440
    telemek
    Participant

    Re: BHWM129 flashing lights

    Checked all usual problems and all ok so changed PCB but fault remained, then replaced PCB tried to test pressure switch by blowing air into it and re-assembled and it worked ok, so could be pressure switch!

    in reply to: BHWM129 flashing lights #389438
    telemek
    Participant

    Re: BHWM129 flashing lights

    Thanks, will check tomorrow.

    in reply to: Zanussi wont start #385925
    telemek
    Participant

    Re: Zanussi wont start

    Checked dryer element today and checked ok on resistance test and leakage but after disconnect wash cycle works so spot on repman, saved me a lot of time and ordering unessecery parts. Many thanks.

Viewing 15 posts - 16 through 30 (of 43 total)