Forum Replies Created
-
Posts
-
Re: big w/pool t/drier parts needed
cheers chris, i seen this bit on the connect site pt no. 481953598594, thinking it was the pulley shaft?, is this the shaft for the drum support wheels then?.
thanks
TELL..
p.s all on special orders. do you know who has them in stock?.Re: just need some part no.s
thanks chris for info. phew! pricey parts through connect again?. Q/tex coming up best prices.
thanks
TELL..Re: AEG upright freezer – 928341004
Mines all in foreign gobbledeyguke as well but look at this. Might help. This is an earlier version, but usually the same from m/c to m/c.
AEG 92834100300 U Arctis 2792-1 GA earlier version. i think i’ve done this right???. technology is going to fast. e’mail on it’s way aswell. if you dont get it e’mail me. but if you use this pnc no: on your disc, it could help.
TELL..Re: Whirlpool built in oven
normly on these m/c’s after a short time i think the timer just goes to 4 bars on the timer, then you reset timer, also i think that you can still use these ovens without the clock set, once the stop has cleared/or when you set temp up-down.
might be helpfull.
TELL,,Re: Stoves DW 616/BB leaking
just check to see if the inset on the breather/vent is tightened, to pull the seal onto the cabinet. when on wash the spray arms splashes water up against the casing, and it can weep past seal, and water trickles down the outer casing, and looks as if its coming from the seam.
spread pointy nose pliers and place on the outer parts of the spokes on the vent, and tighten up. doesn’t take much. think that should help if i’m on the same model?.
Tell..
p.s. somtimes the clamp has dropped off and customer has chucked it out.Re: smeg d/washer. drain pump pulsing on/off.
thanks for the advice, gents. back to call and will check these out.armed with prices for customer,
thanks
TELL..Re: smeg d/washer. drain pump pulsing on/off.
thanks for the replies gents, i take it this appliance puts a pulse out to various components to check they are operational, before it starts, and if not aborts the programme?.
but, would it not come up as a funcional fault with a f/code.
thanks
TELL..Re: connect having a laugh, again
said this before about connect, but dont how they are priceing parts, I found Q/Tex are knocking spots off their prices. I’ve changed,
do you think they have bumped up prices, in this economic crisis?, i think they have, and are going to loose trade if they continue. HOPE THEY READ THIS,
TELL..Re: indesit di620 d/w
check the high pressure sensor, on connect site pt no.5045173458406. just had similar fault on belling d/washer see forum, trade spares posted by tell, read re-i’m back again belling dw604, might help you could be same intermittant fault.
TELL..Re: i’m back about a Belling Dishwasher IDW604 ( 444445898 )
put in the beko part no.672050210069 on connect site, thats what it looks like gents. its the live feed from the pcb through the switch to heater.
TELL..Re: i’m back about a Belling Dishwasher IDW604 ( 444445898 )
no thats the water level pressure switch, if you look at the drawing again mike it should be attached to the hose(45b) via a little spigot/junction, and it fits in there. so if no water in appliance it wont close contacts for live direct to the heater.
ps. just had stoves on phone it has been identified, as a beko part. no.672050210069, and the stoves no. is 082631725.
take note of the number, me thinks it could be a popular part, for when the heater does not work, and people order the pcb instead.
TELL..Re: siemans se25831gb/17
£99.94 direct from bosch direct pt no. 269965 connect are getting silly with their prices at £83.85 + vat
TELL..
ps phone direct on 0844 892 8921Re: Brandt FD292wuii loweer oven overheat protection TOC’s
only one i can see on connect and marsterparts lited is 76X8745
and connect no’s 5031681251172 and 5031680645613
but listed for models FD292BU1 , FD292WU1 , FD292XU1.
any help.
TELL..
