Forum Replies Created
-
Posts
-
Re: Soft Rinse dispensed with soap or rinse water???
I no it might be stating the obvious but you arn’t over filling and accidentally starting the syphoning when you shut the soap draw before starting the machine are you?
Re: Indesit F06 Fault Code?
Done one today F06 door lock or wiring or pcb. The one I had was faulty wiring on the door lock burnt connections. Replaced door lock and wiring but it still needed a new board Arcaidia yet again
Re: CANDY CDI 1012 only washing top half
Are the spray arms free to turn on the bottom? Are they clean from food stuff in the holes is there a 1/2 load option on your model?
Re: Old bendix dryer &…still working fine
Quality machine when that was made across most manufactures.
Re: Samsung rsh1 jbrs makes ice but wont tip it into hopper.
Yes I agree ice maker gear box. I have had this on my 2028 a couple of times take the gearbox apart some times you can sort it if something has come loose.
Re: Samsung RSE8JPUS Display problem!
Check the connections above the door under the hinge cover might just be a loose wire.
Re: Indesit washing machine – stopped working
Have you checked the solenoid valves sounds like one of them is not working possibly.
Re: Hotpoint WDD960 drying temperature
Have you had a read of the instructions about load size for drying they are very small compared to the wash loads just a thought?
If you still feel you have a problem request a technician visits instead of an engineer.Re: Hotpoint BWD129 flashing lights
Does the door lock but the light dosent come on permanently?
Check the carbon brushs could be worn out.
Are you the cx500 John macRe: Hotpoint TCM580
Sorry are we talking condensor model?
If so take heater cover off and fan you will see 4 8mm screws that hold the motor remove them
Rotate motor to get the belt on then looking at the motor you will see screws holding the casings together put plumbing pliers through one and use as a leaver turn the motor until you can get the screws back in.
Hope this helps
