[tj5793]

Re: Watchdoggin

I have worked on indesit and Hotpoint for 13 + years and only seen 1 machine that has done this we have been fitting the brackets on every call that needs 1 for about 2-3 years

[tj5793]

Re: Gas Safety Question

Plastic fittings are not approved for Gas. Would repot it to gas safe or RIDDOR if you feel your not being taken seriously and to cover yourself

[tj5793]

Re: Tools

Tip machine back and slide carbons out more than likely worn out

[tj5793]

Re: Cannon Lincoln 10255G MK2 gas cooker oven not heating

FSD will be faulty not the thermostat 99 {e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} certain I would charge about the same for that

[tj5793]

Re: New World Dual Fuel Range

What area are you in? Might be able to recommend someone in you area

[tj5793]

Re: Zanussi ZWD12270W1

Zanussi did say 10meg or more after a repair on laundry products to prevent daft module faults about 12 months ago Hoover say 150megs on laundry products to prevent silly board faults

[tj5793]

Re: Hot point wml 520

Check the wiring from the motor plug to the plug on the pcb to start with

[tj5793]

Re: samsung american twin cooling question ?

Depends on model but some of the later models have a solenoid diverter valve. What was the original fault?

[tj5793]

Re: Neff Oven Element – Help !

Seams correct to me. Is there a one shot cutout in the element circuit normally on the back of the oven cavity some where?

[tj5793]

Re: EKC 6045X electrolux oven

Yes it shouldn’t cause a problem just heat up quicker the thermostat will control it without a problem

[tj5793]

Re: WASHING MACHINE PRICE 1973

I bought a Creda washer dryer in 1987 from the factory shop for £437 with 33{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} staff discount now your had pressed to by a washer dryer for that price.
2 sets of bearings and I can’t remember how many sets of carbons later it was replaced in 2009 with a Samsung washer that touch wood hasn’t faulted yet but only cost £200 don’t think it will last that long!!!

[tj5793]

Re: wdl 520

I think you may have released the motor brushes and they are now making contact. Check the brushes they should be about 1 inch or more if they are only about 1/2 inch then replace. Common fault on Hotpoint where door locks but nothing else happens

[tj5793]

Re: Whirlpool American style fridge/freezer

Have you looked at the evaporator in the freezer? It may be blocked with ice preventing air flow to the top of freezer and the fridge. If so defrost heater at a guess

[tj5793]

Re: LG Direct Drive plea for help

The hall sensor is usually at fault with any irratic motor action on these machines I am not aware of test results for the hall sensor alot of machines use them but there are no tests available for them

[tj5793]

Re: hotpoint BU72 oven

If your sure both elements are working it can only be the thermostat if the door is sealing correctly

[Author]

Posts