tomdave

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • August 25, 2016 at 2:27 pm in reply to: Daewoo FRS-2021WAL – Replacement PCB #440455
    tomdave
    Participant

    Re: Daewoo FRS-2021WAL – Replacement PCB

    wrong pcb try dae30143b4010

    October 9, 2012 at 1:12 pm in reply to: white knight 77aw condenser dryer #382621
    tomdave
    Participant

    Re: white knight 77aw condenser dryer

    check front fan blade might be blocked or spinning on shaft regards david.

    September 12, 2012 at 7:12 pm in reply to: samsung rls36sbms #381090
    tomdave
    Participant

    Re: samsung rls36sbms

    sounds like its not coming back on after defrost,check evaporotor heater,thermal fuse also check the geared motor opens and closes when you open and close fridge door hope this helps regards david.

    December 1, 2008 at 4:12 pm in reply to: looking for work in north east #270063
    tomdave
    Participant

    Re: looking for work in north east

    contact david or dave at electro services tel 0191 5480200

    February 28, 2008 at 10:34 am in reply to: Leisure RM5CVS #244423
    tomdave
    Participant

    Re: Leisure RM5CVS

    forgot to mention…part says for top oven…there are two thermal fuses fitted to this appliance, both are the same rating for top and bottom ovens

    February 28, 2008 at 10:23 am in reply to: Leisure RM5CVS #244422
    tomdave
    Participant

    Re: Leisure RM5CVS

    look at bek160100578 on connect, picture shown

    July 17, 2007 at 7:01 pm in reply to: Daewoo F/F #220622
    tomdave
    Participant

    Re: Daewoo F/F

    thermal fuse is part no…..dae3017200420 in stock at connect. ….not sure about water problem
    regards tom

    December 11, 2006 at 9:33 pm in reply to: DIPLOMAT ELECTRIC OVENS NOT COOKING #197544
    tomdave
    Participant

    Re: DIPLOMAT ELECTRIC OVENS NOT COOKING

    seem to remember that some of these ovens were fitted with low wattage fan elements and were not up to the job. Have you checked the wattage of the element, if its 1500 watts or less, thats where the problem is.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)