TonyMower

Forum Replies Created

Viewing 14 posts - 16 through 29 (of 29 total)
  • Author
    Posts
  • in reply to: Zan Washer ZWF1621w #329411
    TonyMower
    Participant

    Re: Zan Washer ZWF1621w

    cheers, going blind in my old age. haha.
    thanks again. 🙂

    in reply to: Intergrated Electrolux Washing Machine #327561
    TonyMower
    Participant

    Re: Intergrated Electrolux Washing Machine

    Thanks, will check that.
    Anyone know the diagnostics test for these? Is it the same as the Zanussi ZWF range?

    in reply to: Bosch Dishwasher model SMS69 #325362
    TonyMower
    Participant

    Re: Bosch Dishwasher model SMS69

    Thanks Martin,it just so happens the error we have is E24!! but it would be nice to get a full list.

    in reply to: Bosch Dishwasher model SMS69 #325360
    TonyMower
    Participant

    Re: Bosch Dishwasher model SMS69

    ENR No. is SMS69L02UK/11
    Thanks

    in reply to: whirlpool washer, service light? #308754
    TonyMower
    Participant

    Ok well with recent investigation of the newer W/P AWOD models, we have found that too much detergent can cause this problem (too many suds going where they shoudnt). The appliances we have seen are very new, sometimes first time use. If the appliance you have is a AWOD model then this could well be the problem.

    Generally the service light just comes on because the appliance is timing out somewhere (normally drain) but is functioning properly.

    in reply to: Zanussi ZWF12080W #307390
    TonyMower
    Participant

    Finally got this machine back to the workshop, does anyone know the test procedure if there is one for this appliance?

    in reply to: whirlpool washer, service light? #308752
    TonyMower
    Participant

    Do you have a model number?

    in reply to: Zanussi ZWF12080W #307389
    TonyMower
    Participant

    Re: Zanussi ZWF12080W

    Definately just does nothing at all after door locks, no humming/buzzing of pump or solenoids at all. I was thinking faulty module?

    Appliance purchased from a third party and we repair all their appliances for them, they dont worry about the garuntee/warranty.

    in reply to: Hoover washing machine filling while spinning #300525
    TonyMower
    Participant

    Re: Hoover washing machine filling while spinning

    Does it ‘only’ fill constantly while draining and spinning?

    in reply to: Hoover VHD8122-80 Washer #300227
    TonyMower
    Participant

    Re: Hoover VHD8122-80 Washer

    Having a problem with another one of these models. Just keeps pumping out as soon as i select a program (without pressing start). If i turn selector to off then back to a program then i sometimes get 4 flash error code, have done all the checks and replacements for error 4. Any ideas out there?
    Regards Tony

    in reply to: Hoover VHD8122-80 Washer #300224
    TonyMower
    Participant

    Re: Hoover VHD8122-80 Washer

    Thanks for reply, worked a treat 🙂

    Doe anyone have the fault codes for this machine?

    in reply to: LEC TF6096W F/F #253754
    TonyMower
    Participant

    Just to let you know that the error E4 on this appliance is Defrost Heater Failure.

    🙂

    in reply to: electrolux bdw55 d/w #255761
    TonyMower
    Participant

    Re: electrolux bdw55 d/w

    Ive had same problem with Tricity Bendix D/W’s. I found that the bottom spray arms have slightly split, causing the water to squirt with pressure at the door and seal. As T.B and Electrolux are much the same, the cure is to just replace the spray arm. If you have a another d/w that doesn’t leak, you could try switching the spray arms over to test and see if it work. If all goes well, go ahead and order one.
    Hope this helps you… 🙂

    in reply to: LEC TF6096W F/F #253753
    TonyMower
    Participant

    Re: LEC 6096W

    Still having this problem, just bumping post in case it was over looked.
    Thanks

Viewing 14 posts - 16 through 29 (of 29 total)