Forum Replies Created
-
Posts
-
Re: Beko WM95135LB washing machine
Hi Bernie,
Thanks for the info, we actually discovered it was the motor this machine has a new type of induction motor on it with a PC board attached. Changed the motor and it work straight away.Re: Siemens washing machine F43 error
Hi Martin, we have tried that but no further forward. It looks like the brushes have taken out the module, no matter what you try you cannot cancel the error code plus the start light does not flash.
Thanks for the advise.Re: John lewis oven JLBIOS609
The safety cut is an interesting option, intermittent faults are the most difficult to get to the bottom of. Thanks Martin
Re: Miele PW6055 Plus LP washing machine
Thanks for the information Taff, I think sending the boards to QER is our next step
Re: Miele PW6055 Plus LP washing machine
Thanks for that, I would assume both the chip and switch would be found on the power module?
Re: Samsung RSH1NBRS fridge freezer
This is the small 20mm fuse on the main PCB on top of the appliance, the customer had already changed the fuse when we got there but had kept the old one which had definatly blown.There is only one fuse on the main board. There is a second small board that has 3 fuses on it but these were all OK
Thanks for your advice on this problemRe: Haier Washer/Dryer
Hi Bob can you send me the details for this error? Many Thanks for your help.
PS do you have the part numbers?
tony@arrowdene.co.ukDefinatley no blockages in vent, checked all.
I did leave it after it stopped for about 10 mins, it didnt restart by itself within this time.Added note though, first time i tested it heater pulled about 9Amps constantly untill it shut down. Second time i tested it, it regulated (heater switched on and off) and worked fine for a 30min test. Im still none the wiser with this. Ever known the heater relay contacts to stick intermittantly?
Checked the ntc on the heater, that was ok. it runs full heat pulling about 10amps. I did miss the NTC in the front, not massively experienced with Miele. Wierdly it does work normally without the vent hose on, but im 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure there are no blockages of any sort, also vent is very short and completely direct outside.
The machine is not just thinking its done and finishing early, the vent warning light is coming on. basically it thinks it blocked up but its not.Yeah thats the part number, yes its the metal latch that hassnapped off. Grrrr unhappy customer coming my way lol
