tonyo

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • tonyo
    Participant

    Re: Candy C4400 dishwasher not moving on to next part of cyc

    Many thanks Penguin45 for your prompt advice. I’ll check with uk.whitegoods for a price on the part but I suspect it will be too dear

    Regards and thanks again for your help

    Tony

    in reply to: Candy C4400 leaking #173268
    tonyo
    Participant

    Re: Candy C4400 leaking

    Many thanks Penguin45
    I dismantled part of the black water collector at the base of the dishwasher underneath and it did contain sludge. I’ve cleaned it out and it doesn’t leak now.

    Regards

    A very grateful Tony

    in reply to: Bosch KGV2604 powers up but compressor doesn’t run #171313
    tonyo
    Participant

    Re: Bosch KGV2604 powers up but compressor doesn’t run

    Did you get your problem sorted as some time ago my Bosch F/F developed a fault similar to yours where the compressor switched off when the freezer reached the correct temperature but then would not switch on again when it warmed up. Sometimes however, if I turned off the power switch and left it for a couple of hours switching the power back on sometimes started the compressor and it would again be ok until the freezer reached the required temperature. I did a search on the internet for the fault and found information to suggest there was as simple fix which involed cutting 2 wires and joining them together.

    I contacted Bosch and the told me they had a kit costing around £12. It turned out to be instructions on which wires to cut. I still have the instructions somewhere but it may be worth contacting Bosch.

    Hope this helps

Viewing 3 posts - 1 through 3 (of 3 total)