Forum Replies Created
-
Posts
-
The door appears to be opening and closely with no problem.
I have not been able to find anything conclusive online apart from the following suggestions:
– flashing lights indicate that the water inlet tap is turned off
– this thread: https://www.justanswer.co.uk/appliance/e4j7b-baumatic-bdin1l38b-bk-built-dishwasher-need.html – focusing on salt and rinse aid or a leak meaning water got into the bottom of the unit – suggestion to tilt the machine
– this thread https://www.justanswer.co.uk/appliance/gv5e3-baumatic-bdin1l38b-bk-built-dishwasher-need.html this thread focusing on leak/seapage and the leak float – suggestion to drain machine and/or clean with boiling waterI also called the customer service but they were not willing to share any information on the phone and wanted me to book and pay for a technician visit
Thank you
I’ve just found this similar thread with a similar reply.
https://www.justanswer.co.uk/appliance/ejh54-baumatic-dishwasher-delivered-during-covid.html
“Understood, the hinge does not have an adjustment on this model, the doors are of a significant weight and as you have suggested this would rectify the issue (once fitted).”
I will have to wait and see how it fairs once the door panel is fitted but the tension is so strong that I find it hard to believe that it will not spring shut even once the door panel is fitted.
Thank you – I have the original brackets and screws just waiting for the panel and plinth.
The kick plate/plinth is quite recessed are there any tips on attaching the plinth so it won’t be so sunken?
The dishwasher is integrated but the door panel and plinth are not going to match the kitchen so its not going to be a flush run. It’s an old kitchen so we had to assume the contrast and get an individual door and matching plinth that I will need to cut to size for the appliance.
Thank you. I have found instructions for other models but not this one and I have been waiting for Baumatic customer services to get back to me for some time. It will need adjusting as the dishwasher door currently is hard to open and the tension is such that if I am not holding it springs shut again. I though integrated dishwashers were meant to allow for door tension adjustment?
Two more questions please.
a) do you need to use a drill to fix the screws to the cosmetic door panel or could I attempt to screw them in carefully?
b) do you know how to adjust the tension on the door?Thank you
Hi [USER=”4209″]electrofix[/USER] – thank you very much. Can you please send me that manual. I may be looking at the wrong one.
Thank you for the advice. We are going for a fully integrated one. I am little scared of fitting the decorative door panel though.
Thank you for your reply and information. We didn’t know that.
We have found a Gorenje dishwasher that has 58 depth.
Gorenje GS62010SUK 12 Place Freestanding Dishwasher – Silver:
Product Dimensions: (H)850mm x (W)600mm x (D)580mmWe had contemplated an integrated or semi integrated too; but this also require panel, plinth and handle installation. We would probably just assume the contrast here as matching our existing kitchen would be near impossible.
Do you have to cut panels to size for semi integrated dishwashers or are pre cut panels available?
Thank you
