Forum Replies Created
-
Posts
-
Re: LG Washer Wont Heat?
It was burnt craked wire from heating element. Why that was burnt, should i worry about it?
I put it new connection and it works now normally.
Re: LG Washer Wont Heat?
Ok ill check it, can you say where is place of thermostat and what kind resistance it should show, both of them?
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
I think Bill you were right, condesner was the problem. Also i run factory settings to the machine. It works now perfectly. I have figured that if you put too little clothes to drum, sensors dont work correctly that is feature.
Thank you Bill.
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
it was dry sensor fault. I put it wet damp to the sensors and its works normally. Now i have to find out how to change those sensors..
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
If i try that machine without condenser, is that possible?
And is there betterways to clean that condenser than air?
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
I mean when i start machine there is display what shows where program goes.
dry, iron dry cupboard dry, cooling.
When machine starts light blinks in dry section about 2 minutes, then program jumps over iron dry section to the cupboard dry.
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
I have checked that and in sideways light not goes very good trough. But i have washed that and also cleanit with pressure air.
And im thinkg if that condenser is stucked why program goes too fast? I think if that is stucked program takes longtime to dry because dry sensors tells that there is moisture.
Re: LG TD-C70040E Tumble dryer problem? (wont dry)
I think that two relay are broken in pcb board. But how i can change, because that hole pcb board is glued in silicon mass?
Re: Aeg T560 tumble dryer lift pump make noise and low heat?
Is there any possibilities that pcb board error makes only 2 heater heat?
Re: Aeg T560 tumble dryer lift pump make noise and low heat?
I found it another heater element, where is same 2 heater damaged, im thinking can i replace them together, so i have one working element?
i answer my own question, its impossible.
Re: Aeg Lavatherm T560 tumble dryer lift pump make noise
Here is picture, this is exactly same heating element and only those 2 heater get heat.
http://www.aijaa.com/v.php?i=6092858.jpg
And this the machine AEG T560
Re: Aeg Lavatherm T560 tumble dryer lift pump make noise
Okay thanks.
Another question is, i think there is too little heat in my machine, i found 2 thermal fuses one in the heating element and another, is in exhaust pipe is it possible that another one those fuses is broken, and thats why theres no normal heat?
Dryer get warm, but i think its half that normal heat?
Also heating element is twin model, so i check it that fast when dryer was on, and only one of those heaters get heat.
