Forum Replies Created
-
Posts
-
Re: Second Hand Smeg Fridge/Freezer
Hi
I would assume that the pipe that was encased with ice (frost /snow) was the slightly thickest one coming from inside the casing to the compressor ?.
If that is the case then the cause would either be over charge of refrigerant or the unit running in excess which then causes the refrigerant to build up in the suction line.
A refrigeration engineer should be able to advise once seen.
Bryan
Re: Gas Safe Inspector
Hi
The last inspection that I had last year i advised that things like hob tops,thermocouple and ignition generators was changed by my son who’s not gas safe registered and part of his routine was to gas sniff anything accessible,If gas was found then the house would be isolated and transco contacted.Advised NO gas pipe or fitting was disturbed ect and he had no problems with this.
He even commented on an inspection he went out to due to gas leak which we had changed the hob top on a few weeks before and agreed that it wouldn’t come into our cover as the parts was only cosmetic.
I dont think there is still any clarification across the board and each inspector has there own view.
BryanRe: jlwm 1203 sticking at one minute
Uneven load,unable to complete spin,blockage in air tube ass ?
Is it fully pumping out ?
is it going into a full spin ?
have you removed the pressure hose ?
is it distributing the load correctly ?
Element wouldn’t cause a fault at the end of the wash.Re: samsung rs21jgrs
Hi
Why would you need the compressor start relay for this model as i’ve never changed one before in 10yrs.They don’t go faulty.
Bryan
Re: Samsung Fridge Freezer RS21DCNS Internal Cracking
Hi
As an EX samsung engineer I can confirm that IF the cracks are on the SIDES of the freezer compartment then this could NOT be caused by yourself.If the cracks are on the BASE of the appliance then dependent on pictures it COULD be caused by items being dropped .
Bryan
Re: Samsung Fridge Freezer RS21DCNS Internal Cracking
Hi
This isn’t a common problem with this model but it can happen on any fridge due to expansion compression of the plastic when it cools down or heats up.The liner SHOULD be of a standard to withstand this movement though.How old is the appliance?
Bryan
Re: problem with Samsung fridge freezer RSH1DBMH
Hi
You will need a repair kit which we can supply.e-mail me
Bryan
Re: samsung BF641 fb xeu pcb
Hi
Send the customer back to samsung and tell her to demand that due to samsungs faulty design and the faulty part requiring to change the whole harness and thermal cut outs and PCB and the model has been modified due to the PCB failures she is holding them responsible.
Bryan
Re: bosch wte6920gb04
Martin wrote:
robinsonrobbo wrote:
but I later found out you can get a beko version for a lot cheaper.I’d very much appreciate the Beko part number for that pump please? 😀
5045174121552at connect
canufixit
Re: Oh no! Another electronic nightmare. AEG La72630 EWM2000
:wave:
I’m amazed about your work…well done… but could you used any smd diode from all any other boards which are connected on relays coil…A pint of :beer: is very gooood :bounce: …
Re: Qualtex oven glass glue
Hi
It’s a hight temp silicone so NONE instant set.We use masking tape to hold in place and leave door off on side and advise the customer to refit 24hrs later.Did you read the instructions ?
bryan
