Forum Replies Created
-
Posts
-
Re: Electris hob C N A Trading Appliances mod EC60T L comes
send me your e-mail addy
bryan
Re: GE American FF TFG28PFBWW condensor fan motor
Hi Kez,
Part number WR60X267. ISDAL have them in stock.
Richard
Re: Busy or what??
we on average do 40-45 calls a day, the last couple of months we were booking nearly a week in advance, yet at the moment we are doing calls as they come in, all the engineers are going out with a full day its just harder to get them booked up , 😥
Re: GE American FF TFG28PFBWW condensor fan motor
Hi kez
Do you want the genuine part which is approx £150 or another american motor which does the same job better ? I have the replacement in stock.
Bryan r600a@ffrservices.co.uk
Re: Electris hob C N A Trading Appliances mod EC60T L comes
Hi
ER03 is when the sensors are picking up that something is on the hob.either staining / food ect or that the main board is duff.more likely dirty than main board.
Pressing on the controls will cause the er03 L is the control is locked by user
Bryan
Re: samsung wd8704 rja error he2
They are turning the appliance off before they allow the cooling off period to finish which means the heat box isn’t cooing down and the heat is transferring to the toc.
bryan
Re: SRL628EV defrost sensor for fridge section
Standard RS21 one…just but connect the plug if different.
bryan
Re: Samsung american rsh1dbbp iceing
Hi
Yes it is supposed to cure it but doesn’t always.it also has a habit of causing more damage to the liner behind the evaporator as the heater is on for longer.once the liner is burnt then the appliance is scrap..BUT samsung engineers aren’t allowed to tell you that but was informed to use a botch up sticky foil to patch it up.check behind the evaporator.if it’s damaged then samsung MUST give you a new once as it’s a known defect.
Bryan
Re: prestige PRT325FFCS fridge freezer
Hi Kez,
The ISDAL part number is 9141200116. The appliance is the same as the Frigidaire FRC196FF.
Richard
Re: whirlpool adg 7340
Hello, first post…
This is an old thread, but it matches the problems I’m having with my dishwasher right now, so I thought I’d bump it and see if there are any suggestions.
My dishwasher is a Whirlpool ADG 7540. Towards the end of the cycle there’s a rattling noise from below. At first I described it as a stutter and searching for that lead me to believe that it might have a dodgy askoll pump, but after removing the front plate and watching it in action I’m not sure.
The right-angled rubber hose and the heater are moving around quite a bit with the rattling noise. It looks to me like something is stuck in there.
As per the OP there is a fine grey oily residue on the plastic parts inside – something I hadn’t taken too much notice of.
I’m also unsure who to remove the rubber hose clips to get a look.
Found a good image of the underside parts here:
http://i2.photobucket.com/albums/y2/Penguin45/UnderWplDW.jpgAny help appreciated.
Re: samsung rsh1dbmh
Hi
Nope,the heaters are modified and should come with a repair kit (botch up/cover up kit) to repair the split liner behind the evaperator steel sheet.
If you need one we have them in stock and also the mod kit to stop the ice ball forming top left of evap cover panel.Bryan
