[adv]

am sure ave seen that on a machine before . i thought it was maby extra connectors for a different model .or for a engineer to plug into , to find a fault ?some sort of test rigg ?

[adv]

kwatt wrote:All in the title.

Hope it’s better than the last two!

K.

it surely cant get any worse 😡 h n y fokes

[adv]

whats the original promblem with the machine ?

[adv]

😮 quality

[adv]

electrofix wrote:not had the problem but first check its not leaking steam thats condensing on the floor

Dave

where would the steam come from ? a seal take it ?

[adv]

nobody know much about these then

[adv]

must say your a trier 😉

[adv]

i see you can buy these . how to put them on is a different story . cant see how you can, as most put on in factory .

[adv]

well this was crap blocking fill hose mess filter ,,so must be a fill time out fault ..;)

[adv]

electrofix wrote:could be either or both but you can check the valve

Dave

how do you check the valve ?resistance valvue ?

[adv]

going morn is their a test mode ? for it . says only does it on the 30 min quick wash

[adv]

still reading 😉

[adv]

electrofix wrote:will tell you now the inverter is dud

if the mag only fails it does not blow the fuse

Dave

you heard it from the top 😉

[adv]

jontymox wrote:Success!

Fuse in Module had blown – Fitted a 10 Amp fuse to test, and all well.

Markings on original ESKA fuse M 8/250 G and I wonder if 8 refers to 8 Amps?

Thanks again to all feedback, and help.

jonty

very good so was it just that all along ?:o

[adv]

bet you wished you had walked away 🙁

[Author]

Posts