Forum Replies Created
-
Posts
-
Re: Neff c57m70nogb/03
Gents not sure if fault ER05 is related to the fault we found which was magnetron failure ,hope this helps should anyone else have similar problem ,regards
NigeRe: Rangemaster induction oven top removal
Cheers guys response much appreciated ,had a word with Jonah all sorted.
Re: swan fridge freezer
cheers guys appreciate the reply , sorry for wrong posting, Don hope you’re feeling better.
Re: Whitegood Fires to be debated on Jeremy Vine
Ken, has there been a definitive reason as to why Hotpoint/Merloni dryers have caught fire or is it still in the offing Regards Nigel
Re: beko condensor dryer dcu8230
update we have changed p.c.b and was heating when tested customer subsequently used on Jean prog with one item,no or little heat,do you think this is not enough clothing for sensor to sense,any help appreciated nige
Re: beko condensor dryer dcu8230
cheers Seamy,correct heater fitted condenser cleaned before new heater fitted as I think that was original cause,and sensor bars cleaned as I saw on post here somewhere a while back that f/c could cause this type of fault but thanks for you helpful input as usual
Re: Flashing door light hoover wmh168d-80
Martin door lock working, will let you know but thanks very much for input ,much appreciated,Nige
Re: Flashing door light hoover wmh168d-80
Martin there was no fault code in window,when programed you get the flashing door lock, then when the start button depressed to start machine, the lights start flashing but machine does not start,apparently it stopped full of water in cycle,customer opened filter door and attempted restart but only got above fault,ive metered all components and they all appear ok and to spec any ideas please
Re: beko gas range cooker grill f.s.d
Lawrence I bleive the number you are after is:7757686332,for gmtg95k oven,thankyo for your help,nige 🙂
Re: working on gas cookers information
Is this correct? I am gas trained and if like all electrical calls you safety check at the beginning and end of job ,you must also do the same checks on the gas side,even if you are not checking gas pressures you still must check for correct flame pictures appliance controlfunctions etc,,if they are not right how does a non trained engineer carry out repair? is it a case of “sorry you must get a gas engineer in to do it” not very happy customer me thinks!!
