Forum Replies Created
-
Posts
-
Re: bosch dishwasher code
Nomadpaul my concience got the better of me,rang her to find that she has lived in house for 14 months not d/w age, thats 3yrs,call booked for fri,is this fault the e25 the little pump cover that becomes dislodged?Sorry for wrong info 😳
Re: bosch dishwasher code
No idea,she rang my office and asked specifically for me no one else on recommmendation!so can anyone help thanks
Re: miele dryer t224
washerman,we have an update,when m/c is on with no load ,on normal prog it does not cut out, but keeps running,doing everything correctly,if the dryer is turned off and reset on normal prog again no load,with humidity sensor lifted off drum it cuts out and beeps as if to say no load or humidity level reached which iscorrect [ the lamps now are correct and no fault indication] any ideas nige :rolls:
Re: miele dryer t224
matey!!I sound like a bubble bath 😆 did you have any joy with the fault nige
Re: Diplomat ACA9202
dont know why neutral is missing when you checked for voltage and continuity,but as helpful little jimmy used door as trampoline I would check loom for breakages,ie when opened loom may be ok but when shut it may be oc or visa versa just a thought
Re: miele dryer t224
yes these are the leds that flash no i havent tried this but will,also m/c does not cut out after 1 min with nothing in drum, even with humidity sensors lifted from drum nige
Re: Rusty coloured marks on cutlery
trylooking at basket rack ends they often break or split then rust leaving deposits
Re: Neff D/Washer on Hot Valve
Hi oh ugly one,if it was anything like the Zanussi one’s of times gone by as long as the incoming water wasn’t above 60 degrees it was ok if above this temp it can affect the resins in the regeneration container,spk soon nige hope all’s well :rolls:
Re: bosch SGV53E03GB motor wiring
I’m not sure if this would be the same thing but awhile ago on the bosch made hotpoint I reversed the live[phase] and the capacitor leads and got similar fault changed leads around and it worked fine,one of the other guys may know why hope this helps nige 🙂
Re: AEG HOB DEAD APART FROM AN E CODE
Seamy could be right some sort of LEAKAGE sorry could’nt resist 😆
Re: neff induction hob
ta beever have checked instal and air gap not 4-5mm, advised before fitting plate,cause they didnt believe us we fitted plate ageed by them but still same fault,we have advised more air,will let you know outcome 😉
Re: neff induction hob
Superfix the h and 9 flash but does nothing else until it cools down,it affects both left hand plates at he same time not just one,ie both flash and wont work,the right hand side plates work perfectly 😕 and just to confuse its itermittent
Re: Anybody know anything about Kenwood chefs?
if you look at speed control you have 2x hex head screws,this is to increase or decrease speed i cant remember which way does what but you will soon see ,you have to adjust speed on setting one to one rev/sec,most people used to do this live so be careful!!!!!!!!hope this helps nige
Re: desperate bosch
CheersA1 local water board turned off supply twice in same day,without informing us hey ho.sorry for not replying earlier be happy,St Mirren rule
