Forum Replies Created
-
Posts
-
Re: Beko DRCS68W condenser dry belt + modif info going on Mo
Rograbbit pm me an email address and i will send you some info.
Bob.
Re: Hotpoint induction hob ET6004X
i dont think the power pcb will be the cause of the tripping of the RCD unit, but to answer your question
C00096244 i up to s/n 70903, C00260509 A1 compliant is from s/n 71001.Bob.
Re: Hoover Candy Work ?
well i hope they treat the indie’s better than the last time. im sure Kwatt will have some better comments than me on the subject, just dont take it a face value and be very very carefull out there. Just my opinion of course.
Bob.
Re: FF4DX
the freezer evaporator will be iced up, there is a mod to do on the software on the module, rewrite the eeprom file, or you could just defrost it but watch out when removing the rear cover as the screws are differant lengths and if you swap them over you punture the evaporator when you refit it. 😳
Bob.
Re: Candy CDi1012/2-80 Dishwasher
its normaly poor connections on the water turbine on the air break, gias recommend removing the plug and soldering the wires direct to the small pcb.
Bob.
Re: Hoover DW HDS556MG-80 pressure switch
thats the correct part number for product code 3200023505330848 from the gias website.
have a look at 92490069 its an equivalant.
Bob.
Re: Hotpoint Aquarious WMF720G(UK)R
the programme selector knob has broken, it an easy fix, power off if you are going to do it youself.
Bob.
Re: Lux Built In Microwave…No Heat.
not looked at any tech on that appliance but in general its the high voltage fuse, diode or high voltage capacitor that give a no heat, if the fuse is gone do check the magnatron for earth leakage.
Bob.
Re: HOOVER HNC 382T I need A lesson Please
garn has by the sound of it never done one of these nightmare of jobs on this type of appliance, so just for eperiance if its in a workshop just go for it and do a full strip down, the next time it a lot quicker but it will still get you down. LOL.
Bob.
Re: HOOVER HNC 382T I need A lesson Please
remove the 4 8mm headed screws, the front duct lifts up about 12mm, lift from the bottom and pull towards you, with the bottom out of its retainers the rest is simple.
Bob.
