Forum Replies Created
-
AuthorPosts
-
boggoff
ParticipantRe: Whirlpool S20DRBB32-A/G
Do you loose the supply to the compressor? try running a seperate supply to the compressor only, you may have a compressor problem.15 years working on these never had fault like this
boggoff
ParticipantRe: Whirlpool parts advice
CORRECT PART NO SHOULD ALL PUSH INTO GROVE IF YOU DO HAVE TO CUT OUT SOME MAKE SHORE CUT IS AT THE TOP OF TANK AND SEAL WITH SEALANT
boggoff
ParticipantRe: Whirlpool AWZ512/SE Strange Fault
CHANGE SELECTOR SWITCH
HAD A COUPLE OF THESE TRIED CLEANING CONTACTS ON SWITCH BUT HAD TO REPLACE SWITCH IN THE END PART NO 481227328282boggoff
ParticipantRe: w/pool american 8586 403 15000
UNPLUG APPLIANCE ,LEAVE FOR 2 MINS SWITCH BACK ON IF COMPRESSOR AND CONDENSOR FAN STARTS STRAIGHT AWAY REAR BOARD REQIRED
boggoff
ParticipantRe: W/pool AWG349/4 Washer Dryer 8537 3041 5400
air way proberly blocked ,check hose into tub
boggoff
ParticipantRe: Filter display grief
Press and hold reset button for about 30 sec or it goes to 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}
boggoff
ParticipantRe: american whirlpool fridge/frezze with ice maker
condenser fan probley not working (back of appl) or blocked condenser (under fridge with dust /hair etc )
boggoff
ParticipantRe: Whirlpool Ice Maker Broken
check for 240v on ter 4 blu and 1 brn on emitter terminals r/hand with door switch closed if no volts rear board faulty
April 16, 2009 at 5:27 pm in reply to: Whirlpool American F/F not cooling properly – please help! #283316boggoff
ParticipantRe: Whirlpool American F/F not cooling properly – please hel
i think the condencer cooling fan is not working this causes the centre divide between fridge and freezer doors to become hot its quite common on this model for the fan motor towear out
boggoff
ParticipantRe: Whirlpool ARZ726/B
check wiring loom at bottom of freezer door have had a number with broken wiring
boggoff
ParticipantRe: whirlpool 10kg tumble dryer 3RAW2480EMQO
I think the motor is trying to start in the run winding centrifugal switch on motor
boggoff
ParticipantRe: Whirlpool American fridge S20B RSB21-A/G
C displayed in fridge temp display indicats fridge sensor failure
check your connections on the back board,4 pin connector is the sensersboggoff
ParticipantRe: Whirlpool AWZ7913 – start button
very easy repair just remove control panel you’ll see problem you will require pt no 481251318172 only a couple of quid
boggoff
ParticipantRe: Whirlpool f/freezer ART514-1H Stat housing removal
squeeze light switch plunger top and bottom and pull towards you, plunger and spring will come away screw underneath remove and pull complet fitting towards you
boggoff
ParticipantRe: WPL ADP7966 DW
optical water indicator in right hand side of sump this has ntc combined
if appliance runs at 40oc ok could be heater stat opening and closing at higher temp -
AuthorPosts
