clayside

Forum Replies Created

Viewing 15 posts - 271 through 285 (of 362 total)
1 2 3 … 18 19 20 … 23 24 25
  • Author
    Posts
  • January 17, 2008 at 6:22 pm in reply to: Whirlpool ADG 957 #239874
    clayside
    Participant

    Re: Whirlpool ADG 957

    Hi brian, Thanks for reply. I have no info at all on dishwasher so any help would be appreciated. Its built in and I don’t want to pull it out it not needed. Look foward to receiving info.Regards Clayside

    January 17, 2008 at 6:00 pm in reply to: Mystery Neff built in, single oven. #237123
    clayside
    Participant

    Re: Mystery Neff built in, single oven.

    If you input 073638 to BSH online it shows it as sub for 081958. But if you feed in 081958 it is shown as still available, so take that it should be ok as replacement. I take that fan is running at full speed, oven has correct wattage element and door closes ok. Clayside

    January 17, 2008 at 5:04 pm in reply to: Whirlpool ADG 957 #239872
    clayside
    Participant

    Re: Whirlpool ADG 957

    Can any Whirlpool engineers help please. Regards Clayside

    January 16, 2008 at 7:44 pm in reply to: Miele parts #239866
    clayside
    Participant

    Re: Miele parts

    Last part no and price for W806 motor I have is Part No 5328275 £307.00 plus VAT. Can’t find Part No 291096 all miele part No’s are 7 digit

    January 15, 2008 at 7:54 pm in reply to: Miele motor #239748
    clayside
    Participant

    Re: Miele motor

    Hi ANDY, Part No 3946858 £149.00 plus carr plus VAT

    January 14, 2008 at 5:42 pm in reply to: miele w754 #239563
    clayside
    Participant

    Re: miele w754

    Try the vent hose at top of suds container ( hose fits from dispenser to suds container ), have had some block at that point then machine air locks. Clayside

    January 12, 2008 at 10:34 am in reply to: neff hinges #239315
    clayside
    Participant

    Re: neff hinges

    Forgot to add E No 195 305 776 will find it on BSH site. Clayside

    January 11, 2008 at 7:22 pm in reply to: neff hinges #239314
    clayside
    Participant

    Re: neff hinges

    Should be GB1057 73 LHCS. This is later version of oven. Hinges come as a pair now Neff part no 481827. Connect part no 5031 6831 93555
    Qualtex 016812. Regards Clayside

    January 10, 2008 at 6:02 pm in reply to: 45 cm semi dishwasher #239249
    clayside
    Participant

    Re: 45 cm semi dishwasher

    Thanks Don.
    Clayside

    January 10, 2008 at 3:24 pm in reply to: Creda 47908 loom #239247
    clayside
    Participant

    Re: Creda 47908 loom

    Thanks Martin, no wonder I could’t find it. will replace wiring section.
    Regards Clayside

    January 9, 2008 at 8:02 am in reply to: Miele D/w G525 #239005
    clayside
    Participant

    Re: Miele D/w G525

    Hi Chris, Part No is 1300782 £62.66 plus VAT. Is it leaking out of vent at back right hand side if so could be mixer ball stuck. Undo top fixing of mattrix (the smaller one) then turn machine to fill for a few secondsa small ball size of a pea should end up in base filter ball is yellow or red.I sometimes move ball off seat by sticking little finger in hole and moving it.If unit needs replaceing it comes out of base, just room to get it out but mind fingers as steel edges very sharp. Hope this helps Clayside.

    January 3, 2008 at 1:41 pm in reply to: miele heater #238407
    clayside
    Participant

    Re: miele heater

    Hi John, Part No 6260480 £67.35 plus vat. Regards clayside

    December 31, 2007 at 4:01 pm in reply to: miele prestige plus #238235
    clayside
    Participant

    Re: miele prestige plus

    If my menory is correct machine soaks with cold water from 30 minutes to 2hours in 30 minute steps. Machine then uses this water for main wash.
    your can download copy of instruction book from miele.co.uk then go to customer support / instructon books.
    raegards clayside

    December 27, 2007 at 7:23 pm in reply to: neff dishwasher heater #237901
    clayside
    Participant

    Re: neff dishwasher heater

    Sounds like it could be circulation pump fault. impeller worn or restricted. Poor pressure output from pump means no heat

    December 27, 2007 at 6:42 pm in reply to: Miele g1270 #237956
    clayside
    Participant

    Re: meile g1270

    Yes F14 poor output water pressure from circ pump IE low water intake, level pressure switch faulty, circ pump siezed or impeller blocked etc.
    regards clayside

  • Author
    Posts
Viewing 15 posts - 271 through 285 (of 362 total)
1 2 3 … 18 19 20 … 23 24 25