Forum Replies Created
-
AuthorPosts
-
clayside
ParticipantRe: Siemens SN66T091GB/11
Hi Paul,
Yes impeller cover clicked in place. Good point about water pressure as house has very high water pressure and machine worked after I cut pressure down at tap. On quick wash should it fill for just a couple of seconds, run circ pump then fill on and off 2 or 3 times. It didn’t fill water intake on left hand side, just ran down into base? Havent heard from customer for a couple of days so hope all is well.clayside
ParticipantRe: Miele fridge freezer
Fault Codes
No 1 LED and Super Led flashing from ser no 40/
Fridge air temp sensor faultyNo3 LED and super Led flashing
Fridge evaporator temp sensor faultyNo5 LED and super Led flashing
Freezer evaporator temp sensor faultyclayside
ParticipantRe: Miele G2872 SCVi dishwasher
Picture no 90 it is part no 5874780
Claysideclayside
ParticipantRe: Bosch WAE washing machine
Yeah, looks more and more like a PCB problem.
clayside
ParticipantRe: Miele WT945
Only drum and spider assembly supplied. Two types model WT945 drum is part no 6519802 or for WT945S its part no 5806003. Bearing and seal kit part no 3589003 for both.
Claysideclayside
ParticipantRe: Bosch WAE washing machine
gen carbons fitted. have tried another motor still the same
clayside
ParticipantRe: Miele WS5406 Brushes and Door Lock
Carbon brushes part no 3026790 door lock part no 3595082
Claysideclayside
ParticipantRe: Neff B6774NOGB/02 microwave fault code
Had similar fault on same model oven, found the glass had carbonised between glass and inner frame ( looked like very small chip in door frame enamel) replaced frame part no 444512.
This was in September and machine still working ok. Don’t know why it shows sensor fault (mine did as well ) but it cleared fault.
After I fitted glass and sensor fault was active found when microwave was on during the 10 seconds if you looked you could see arching on edge of glass at times where chip was. Hope this helps.clayside
ParticipantRe: Bosch WFR2460GB/01
Thanks Martin
clayside
ParticipantRe: Miele W902 wash light flashes all through prog.
It’s mounted in the heater element gasket dead in the middle, just pulls out
clayside
ParticipantRe: Miele W902 wash light flashes all through prog.
If element and wiring ok then would look at ntc or power electronic
clayside
ParticipantRe: MIELE FRIDGE FREEZER – KFN8462S – F2 FAULT CODE?
Fridge evap ntc faulty part no 7323302 sensor kit
clayside
ParticipantRe: Miele W902 wash light flashes all through prog.
Wash light flashing indicates a heating fault of some kind, ie element, wiring, sensor, board,
claysideclayside
ParticipantRe: NEFF Built in oven GB105671HCS
Yeah, still got all my microfiche for BSH products. Don’t use them much, just handy to have when needed. :rolls:
claysideclayside
ParticipantRe: NEFF Built in oven GB105671HCS
Was 080738 two stud fixing which is replaced by 083517 one stud fixing. connect ELE4274 or Qualtex ELE4080 for non gen.
clayside -
AuthorPosts
