[clockworkone]

Thanks for that. Expensive little bugger.

[clockworkone]

Pressure chamber is clear. No obvious play in impellor.

[clockworkone]

Quinnspares special order or amazon pld1822. Retailed by Paxanpax so unsure what quality will be like. I just heated up the pliers version and made the tips a bit wider. Getting too sore on the old fingers without them.

[clockworkone]

Thank you Dave.

[clockworkone]

Rats nest under machine.

[clockworkone]

Thank you very much Dave.I am afraid i am pretty old school with some of this electronic terminology. I may be wrong but would a blockage in circ pump trigger this fault.

[clockworkone]

Many thanks

[clockworkone]

Thank you both. Appreciate that.

[clockworkone]

Thank you Jem for the email.

[clockworkone]

Thank you Dave. Email is repairspaul@gmail.com. It does look like it is a whole gearbox required but the only ones i see are in America. Trying to find a price and supplier. Thanks again. Paul

[clockworkone]

Thank you Ray.T. For future reference it was a bad connection on grill door switch plug at back of oven.

[clockworkone]

Quite common problem now. I use a long cable tie. Put tie on loosely through holes under paddle and holes in paddle. Fit paddle and then tighten tie. Cut tie and I just run a file to to where i cut tie. Don’t think superglue would last too long.

[clockworkone]

E07 is pressure switch or related wiring. Can’t see anything for E00.

[clockworkone]

Thank you Dave.

[clockworkone]

Thank you Dave. As you say it’s not a listed error code. I have never seen this pop up on these machines. Had a look at service manual and there is no mention of it. Has to be a board config code or something like that. Thanks again.

[Author]

Posts