[clockworkone]

Re: h/point dw fdm550

thanks for that jim.

[clockworkone]

Re: zwf12070s

had two of these in recent weeks.blown inlet valves.1 main wash and 1 pre wash.blown triac on board both times.diagnostics is only way with these.paul

[clockworkone]

Re: wms 38 door lock light flashing

thanks for that.spring not the best so will change on tues.paul

[clockworkone]

Re: Zanussi washer fx1265w

for relays i find radionics.ie a good place.regards paul

[clockworkone]

Re: Whirlpool 3RLSQ8000J03

pm your email address.paul

[clockworkone]

Re: hotpoint aqxxf149-p1

update on this one.wife rang me with correct problems.(husband told me different storey) machine will wash and rotate but will not ramp up into spin.also error f2 showing(motor jammed or tach off) presume its the latter as it rotates during wash. apologies for the incorrect symptoms.paul

[clockworkone]

Re: polti spares

thank you don. do not have acc with them but have just downloaded application form and will send off asap.thanks again.paul

[clockworkone]

Re: wf541 dispenser and valves

thanks don your a star.paul

[clockworkone]

Re: hoover dw

thank you phil have had a read and it answers quite a few common probs.this dw was surging and stopping and programmer lights were going on and off in synchro.customer has told me that over christmas his power was very eratic ie lights would all dim if he put too many appliances on. was wondering if dw could have been spiked with power going up and down.

[clockworkone]

Re: zan iz12 carbons, sole motor

thank you mike.

[clockworkone]

Re: masterpart deliveries

thank you.paul

[clockworkone]

Re: help wanted with part no tr/bendix 1417 bna

thanks Don for the help.this job is quite a trek for me.have a few stats on van so hopefully will get it sorted.masterpart or my suppliers in ireland unable to help me with this one cos of age of oven. paul

[clockworkone]

Re: whirlpool 3rlsq 8033swd info and multiple repairs info

many thanks martin for the info.was wondering can someone explain how to remove casing on this model.i think its going to be a watched job.does control panel just flip over to release casing.paul

[clockworkone]

Re: xou90fp belling oven element no

many thanks mike, suspected the hpt creda element might have been right.will get both just in case.thanks again. paul

[clockworkone]

Re: hotpoint w/dryer loose top weight

job done ,customer amused at the set up but works a treat.popped the top off this eve to have a look and everything good.needless to say was not able to give guarantee.the technical bit involved heavy duty ties,6 foam pad pan scourers to pad out between concrete and drum and contact adhesive to stick pads to concrete. enjoyed this one.paul

[Author]

Posts