Forum Replies Created
-
Posts
-
Re: Wpl Top loader washers
dont know the age of your m/c but corrosion on spin tube will cause a slow spin on these, expensive repair as outer tube will be corroded as well. as dave said these are a very easy stripdown .had one that had not been used for a while and after stripdown and a bit of freeing of clutch and brake m/c kicked back into life and ran fine(cap is 22 if memory serves me right but check it out before you put one in)paul
Re: hotpoint sdw60
top spray arm fixing nut with seal worn at back of top tray.should feel slight resistance when pulling out tray.if not seal worn.
Re: w/machine for mother in law
thanks fellas for the valued advice. should keep me in her good books for another while.paul
Re: miele w404 inlet valve
thanks for that mike,it does look normal ok.just been watching another post on trade technical about not being able to reset miele machine and code once repaired.we dont get these m/c around here so this is a rare one to me.paul
Re: Miele error codes – can you or can you not reset them?
very interesting post andy.unfortunately i can throw no real light on topic.its just that got a call today from a customer that has a miele w/m in her shed that is leaking after cold snap.displaying inlet fill error. was quoted 88euro for valve from miele so do not want to get caught with it. surely they would not sell me valve and then expect cust to fork out for miele engineer to come and clear fault code.will fire off email in am to area rep and see what he says.paul
Re: miele w404 inlet valve
my god have you seen the price of these 88 euro.and this woman has it in a shed.for that money you would nearly have to bring it to bed with you..rang miele ireland no chance of getting trade prices there.does anyone know can i adapt another valve to suit. are there different size outlets or restrictors on these.paul
Re: fdw60 again
thank you whiskey-six,i have manual and have gone through process to take it out of test mode but it still will not budge. going to pick up tonight and have a good look tomorow.thanks again.paul
Re: hpt fdw 60 schematic please
jim you are a real star at moment for me,having a bit of a run on hpt dwashers at mo and have to be honest not my strongest subject.many many thanks again.paul
Re: h/point dw fdm550
thanks again jim,yes it is a smart reader one,was wondering if relay on these can be replaced without having to reprogramme after disconnecting.paul
Re: Candy Nova CD 112 diswasher
whiskey-six, just wondering if i could have a copy too please.quite a lot of these fine? machines around here.paul
