Forum Replies Created
-
Posts
-
Re: non genuine Hotpoint dryer shaft kit – rubbish
Yep I also had a non genuine shaft snap in a week recently. And has anyone had the ready assembled WMA door handle kits, the hooks have been put in the wrong way round !- Although I think the latter was a connect part
Re: rubbish non genuine dryer capacitors
Ok I admit a little exaggeration, 15 mins about right. Once fan is removed and you have figured how to twist the fan housing in order to pull it out..
Re: rubbish non genuine dryer capacitors
Replaced a Hoover condenser one today. Its a 2 minute job if you have nimble fingers, just remove the front fan
Re: Vehicle
Food for thought….. The wife has a vauxhall zafira, and only really uses it for school runs. So I’m starting to think it may be cost effective to just use that with magnetic signs on instead of purchasing another van
Re: Hoover Vision HD condenser dryer showing tank full
I’d have thought the heater would cut out if the water full light was activated ?
Re: any easy ways of chnging the wm6152 lifter (2705570400)
Could be screws holding them in, accessible from the sump ?
Re: Whirlpool Tumble Dryer Fault
Update: The dryer runs, heats up and finishes the cycle. However the clothes are slightly damp at the end of the cycle and not completely dry.
Have removed sensor bar and cleaned all debris from behind it, checked all stats, and thermistor. Still cant get my head around this one !Re: Whirlpool Tumble Dryer Fault
I’ve also found its working when damp clothes are put in it. But you would have thought that a timed dry would heat up whether there are clothes present or not?
Re: Whirlpool Tumble Dryer Fault
I’m having the exact same problem. Has anyone had any joy with these ?
