crockett

Forum Replies Created

Viewing 15 posts - 1 through 15 (of 37 total)
  • Author
    Posts
  • in reply to: AmicaZWM616W #456328
    crockett
    Participant

    Re: AmicaZWM616W

    crockett wrote:Hi all , I have an Amica zwm616w dishwasher that will not fill. It drains ok but no power is coming to the intake soloinoid valve.both pressure switches work ok as dose the float switch.there is one flashing lights that lasts for a short period of time and then it goes off any ideas what I might check next. I have yet to check if the circulating pump may be stuck/ blocked and maybe cause a circuit block to the inlet valve. Any advice is much appreciated, Crockett.

    in reply to: Whirlpool TD AWZ7814AL flashing lights. #395463
    crockett
    Participant

    Re: Whirlpool TD AWZ7814AL flashing lights.

    Thanks very much for that Jem,
    regards Crockett.

    in reply to: Bosch FD8067 FF icemaker wont empty #378806
    crockett
    Participant

    Re: Bosch FD8067 FF icemaker wont empty

    Result ! corner broken off ice tray, that when in place at the end of first half of rotation twists the plastic ice cube container,therefore loosening ice cubes in the upside down position over the hopper and the cubes drop down solution ,replace ice tray or if you can repair old one, hope this helps someone in the future.
    Regards crockett .

    in reply to: Whirlpool built in oven pcb. damage. #385648
    crockett
    Participant

    Re: Whirlpool built in oven pcb. damage.

    Hi again I forgot to include model of the above post, its a whirlpool built in cooker AKZ 196/ix.
    thanks crockett .

    in reply to: Zanussi zdt6244 integrated dishwasher #382721
    crockett
    Participant

    Re: Zanussi zdt6244 integrated dishwasher

    Thanks Jem and Colin full of salt and rince aid no change and wired properly no change,still as dead as a dódó.Cheers Crockett .

    in reply to: Zanussi zdt6244 integrated dishwasher #382720
    crockett
    Participant

    Re: Zanussi zdt6244 integrated dishwasher

    Thanks Colin,I’ve checked that and I have power to the board. The programme light comes on and changes to any required one but there just isn’t a gig out of the machine not even a noise ,thanks again, regards Ben.

    in reply to: Zanussi zdt6244 integrated dishwasher #382719
    crockett
    Participant

    Re: Zanussi zdt6244 integrated dishwasher

    Thanks Jem ,only out of salt I’ll top both up and give it a go ,regards Ben .

    in reply to: The Fault Code Guide #369765
    crockett
    Participant

    Re: The Fault Code Guide

    Looking forward to the android version thanks for the update.crockett .

    in reply to: Tricit bendix WDR1040w no spin. #379573
    crockett
    Participant

    Re: Tricit bendix WDR1040w no spin.

    Thanks canufixit will give them a ring if nothing else comes in before tomorrow,thanks again for your reply,regards crockett.

    in reply to: Bosch FD8067 FF icemaker wont empty #378805
    crockett
    Participant

    Re: Bosch FD8067 FF icemaker wont empty

    Fan works ok ,thanks eastlmark.crockett.

    in reply to: Bosch FD8067 FF icemaker wont empty #378803
    crockett
    Participant

    Re: Bosch FD8067 FF icemaker wont empty

    Thanks for your help eastlmark,I did see a small capsul like item with two wires from it sited in the middle underneath but touching the outside bottom of the ice tray clipped in and covered outside with polystryine, Im not 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure what this is but my best guess is that its a defrost sensor and I dont see anything like a defrost heater on or near the ice cube tray. Any help / information on any of the above will be much appreciated,thanks again eastlmark and thanks all for reading, crockett.

    in reply to: Bosch FD8067 FF icemaker wont empty #378801
    crockett
    Participant

    Re: Bosch FD8067 FF icemaker wont empty

    Thanks Eastmark,
    the E Nr is,Kan58A40/05.hope this helps,regards crockett

    in reply to: Tricitybendix WDR1040W #377527
    crockett
    Participant

    Re: Tricitybendix WDR1040W

    Thanks again Criscold /Colin for all your help .I’ve just downloaded that manual and I will go through it with the customer,
    regards crockett.

    Sent from my GT-S5830 using Tapatalk 2

    in reply to: Tricitybendix WDR1040W #377525
    crockett
    Participant

    Re: Tricitybendix WDR1040W

    Thanks Criscold for your prompt reply and does this mean that the customers machine is not faulty at all and is meant to stop at 10 and be moved forward if required?.
    your response is very much appreciated. crockett.

    Sent from my GT-S5830 using Tapatalk 2

    in reply to: Norcool cold room #376220
    crockett
    Participant

    Re: Norcool cold room

    part of the norcool company was taken over by frigoglass a Greek co.involved with the frigorex brand of refridgerated drinks merchandisers widely available,the above or their agents may be able to help. crockett.

    Sent from my GT-S5830 using Tapatalk 2

Viewing 15 posts - 1 through 15 (of 37 total)