daisbiz

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 35 total)
  • Author
    Posts
  • in reply to: ikea appliances #356919
    daisbiz
    Participant

    Re: ikea appliances

    ikea are doing a lot of lux products as well as whirlpool,the warranty covers 5 years mechanical breakdown so tis a good deal.

    in reply to: whirlpool dishwasher adp5740 #357062
    daisbiz
    Participant

    Re: whirlpool dishwasher adp5740

    hi,7 flashes ,water tap closed,inlet hose blocked,inlet valve defective,flow meter failure,water indicator failure. 🙂 flow meter on the l/h/s from front view behind side panel.

    in reply to: whirlpool 6th sense fault f13 #357092
    daisbiz
    Participant

    Re: whirlpool 6th sense fault f13

    hi, this sounds like a door interlock problem,can u supply ur 85 number and ur serial number should be on ur door or at the back of machine will help to find fault code out thanks.. 🙂

    in reply to: whirlpool 20 rbd 4a+pt no ice #355222
    daisbiz
    Participant

    Re: whirlpool 20 rbd 4a+pt no ice

    that the mechanics are ok and it sounds like a backboard 😐

    in reply to: whirlpool 20 rbd 4a+pt no ice #355219
    daisbiz
    Participant

    Re: whirlpool 20 rbd 4a+pt no ice

    1108 so its 11 week of 2008,anyway turn ff off for about 2 minutes,turn ff back on open “freezer” door and activate the freezer light switch 4 times this will send ff into selftest,on freezer side numbers will shown up as 07-06-05-04-03-02 is a 2 minute test all the rest are a couple of seconds the if the display comes up as 00-0 the mechanics are ok,if u dont go into selftest 1st time try again ie turn off 2 minutes,to exit self test activate freezer light switch 4 times again or after a couple of hours it resets itself.ff will go back to factory settings ie -18 and 5,this will test the icemaker side.hope this helps.

    in reply to: whirlpool 3rawz480esqo tumble dryer #356284
    daisbiz
    Participant

    Re: whirlpool 3rawz480esqo tumble dryer

    pulley wheel for the belts,position number is 2730,w/pool part number is 481952888108.please check the part your self as there are 2 on this machine,other is fitted to the motor. 🙂

    in reply to: Whirlpool AWM 328 dishwasher – lower spray bar #356341
    daisbiz
    Participant

    Re: Whirlpool AWM 328 dishwasher – lower spray bar

    Hi ive got the awm328 as a washing machine not a dishwasher,can u give the 85 number its on the right hand side of the dishwasher door and its 12 digits long other number also helps 🙂

    in reply to: whirlpool 20 rbd 4a+pt no ice #355217
    daisbiz
    Participant

    Re: whirlpool 20 rbd 4a+pt no ice

    how old is machine,some u can self test,the serial number gives the age.sounds like the backboard tbh.

    in reply to: whirlpool 20 rbd 4a+pt no ice #355212
    daisbiz
    Participant

    Re: whirlpool 20 rbd 4a+pt no ice

    hi there is a two way vavle in the back one pipe goes to the water dispenser and other to the ice maker maybe blocked.disconnect and blow up it.

    in reply to: wirlpool american style top loader washer #355268
    daisbiz
    Participant

    Re: wirlpool american style top loader washer

    hello.been to a couple of these myself,over time the clutch wears down making the motor work harder than it should.put a nice big heavy wet load in and if it struggles to get into spin that may be your problem.

    daisbiz
    Participant

    Re: Zanussi TC7102W condenser dryer water indicator light on

    had the same problem,mine was because the fitting on the water tank had broken and was not passing water from the reservoir to the tank there like push fit pins on both ends of the tank and res.got my bits from connect btw.

    in reply to: Whirlpool fridge freezer S20DRBB American Style #353032
    daisbiz
    Participant

    Re: Whirlpool fridge freezer S20DRBB American Style

    cf is comunication failure try new back board.

    daisbiz
    Participant

    Re: Whirlpool Top loader, 3RLSQ8533JQ1 – painfully slow hot

    just a suggestion swap the hot and cold inlet pipes on the back of the machine if the hot comes through ok connected to the cold side then its the valve gone, ➡ select a cold setting to test 🙂

    daisbiz
    Participant

    Re: Whirlpool ADG 7440 Erro continuous beep 7 flashes with p

    reg.dosage with flowmeter is what the complete part is called,if u supply ur 85 number sited on the right hand side of the dishwasher door “metal door”i could give u the part number 😀 hope this helps.

    daisbiz
    Participant

    Re: Whirlpool American fridge freezer power problem trips RC

    maybe your defrost element that comes on about once every 24 hours will also come on if it needs a defrost as you power machine back up.

Viewing 15 posts - 16 through 30 (of 35 total)