Dave_Conway

Forum Replies Created

Viewing 15 posts - 3,151 through 3,165 (of 12,426 total)
  • Author
    Posts
  • Dave_Conway
    Participant

    Re: Ariston ADL120FR Washing mach bearing kit-determining mo

    W113 has 6203 and 6204 bearings so I think the likely kit you need is this one

    Dave.

    in reply to: Testing Thermostat #170348
    Dave_Conway
    Participant

    Re: Testing Thermostat

    Then you need 1741124 HERE 🙂

    Dave.

    in reply to: Indesit DG6100W tripping rcd. Circulation pump faulty? #170296
    Dave_Conway
    Participant

    Re: Indesit DG6100W tripping rcd. Circulation pump faulty?

    iandms wrote:almost (but not quite) total resistance between red or blue terminals to pump body

    There’s the problem then 😉

    Try the drying out and see if you get total open circuit to the body as it should be otherwise new motor/pump required.

    Dave.

    in reply to: Diplomat ADP8234 control pcb #170368
    Dave_Conway
    Participant

    Re: Diplomat ADP8234 control pcb

    696290726 Graeme 🙂

    Dave.

    in reply to: “Ooooh Matron” ? #164497
    Dave_Conway
    Participant

    Re: One to keep an eye on.

    iadom wrote: 😯 …which model of Hotperloni D/W gets up to 95° 😆

    Most of them…..unintentionally 😉

    Dave.

    in reply to: “Ooooh Matron” ? #164495
    Dave_Conway
    Participant

    Re: One to keep an eye on.

    iadom wrote:I did think he may be a Hotpoint/Indesit engineer

    Correct 😉

    Dave.

    in reply to: LG LD-12BS6 #170261
    Dave_Conway
    Participant

    Re: LG LD-12BS6

    Now in the known error codes also 🙂

    http://www.ukwhitegoods.co.uk/modules.p … 5753#75753

    Dave.

    in reply to: **KNOWN ERROR CODES** #103893
    Dave_Conway
    Participant

    Re: Known Error Codes

    LG Dishwasher Error Codes

    IE – Inlet error – 10 minute time out on fill

    OE – drain error – 5 minute time out drain time error

    EI – leak error – water level in tub drops during use

    FE – overfill error – excessive water in tub, drain pump activates

    tE – temperature error – thermistor resistance incorrect

    HE – heating error – no heat (time out) or temperature reaches 95C

    Lucky Goldstar

    in reply to: Elba oven element #170272
    Dave_Conway
    Participant

    Re: Elba oven element

    I can get it in a couple if days for you no problem.

    An email to spares@ukwhitegoods.co.uk please if you’d like one 🙂

    Dave.

    in reply to: STOVES DW601/2B Dishwasher. #170263
    Dave_Conway
    Participant

    Re: STOVES DW601/2B Dishwasher.

    This one catches everyone out 😉

    It’s a Brandt and the model is DW60I/2B (note the I not a 1).

    The door seal is part number 31X9540 but if it’s leaking from the corners, check the lower spray arm for a split down the seams as that is very common on these, part number for the arm is 31X9985

    Dave.

    in reply to: AEG Oven #170259
    Dave_Conway
    Participant

    Re: AEG Oven

    3302081017 is the 110C thermostat

    8996619267611 is the thermal cut out (common failure)

    3004157370 the knobs

    Dave.

    in reply to: Rangemaster 110DFNG fan oven element/ motor #170222
    Dave_Conway
    Participant

    Re: Rangemaster 110DFNG fan oven element/ motor

    Yep, I can no problem.

    PM as usual 🙂

    Dave.

    Dave_Conway
    Participant

    Re: AEG single built in cooker,need it identified for the En

    The full part number is 8996619126536 at around £30 trade genuine, but:

    Connect – ELE4585
    Masterpart – AG1407

    🙂

    Dave.

    in reply to: jackson j.123w dishwasher #170237
    Dave_Conway
    Participant

    Re: jackson j.123w dishwasher

    It’s a Brandt 😉

    Feel behind the heater chamber, there’s a manual reset stat there that will have tripped I expect.

    Then tell the customer to stop using 3-in-1 tablets 😀

    Dave.

    in reply to: Rangemaster 110DFNG fan oven element/ motor #170220
    Dave_Conway
    Participant

    Re: Rangemaster 110DFNG fan oven element/ motor

    Fan element A094693
    Fan motor P084770

    Connect and SEME are the best bet normally 🙂

    Dave.

Viewing 15 posts - 3,151 through 3,165 (of 12,426 total)