Forum Replies Created
-
Posts
-
Re: cooker hood motor
KSEV10X is the Smeg model it fits, wiring diagram on the way via email 🙂
I don’t know if it will help much though as it just a wiring diagram, no speed indications etc.
chalky wrote:besides my suppliers dont seem as efficent lately, for some reason!?
:stir: 😀
Dave.
Re: Rangemaster 110 – Timer/clock faulty
It will almost certainly need a new timer I’m afraid.
To identify the correct one, the serial number is required, this will be inside the right hand warming/storage drawer.
Dave.
Re: Indesit WG1130T Drum Noise
barnaby wrote:I havent tried it without any clothes, will give it a go tomorrow
A bit chilly this time of the year isn’t it ? 😯
😆
Re: Diplomat ADP 8112 reset switch
Washergirl wrote:or is it in the machinery electrical bit underneth
Yep, underneath I’m afraid.
Power off please when checking :zap:
If you’re unsure, check the repairs@ link below for an engineer 🙂
Dave.
Re: Hotpoint CTD80 stats
The Ariston ADE70CFR uses the same heater and shows 1703200 as the cut out kit so I would assume that’s the one 🙂
Dave.
Re: cooker hood motor
What the hell are you up to now you old bodger ? 😆
If you let me have the Belling model I may be able to help with a wiring diagram and possibly a Smeg one if you have the motor part number ?
Dave.
Re: Getting the brushes out of a Bosch WFL2260
The drum spins both ways while it’s washing and that isn’t actually relevent to the brush fitting, it’s the angle of the holder on the motor as the new brushes have angled ends, Gegsy’s post above tells you all you need to know regarding fitting 🙂
Dave.
Re: Smeg Dishwasher Model DWI67.1
Circualtion motor/pump complete is 695210370
The pump on it’s own is 690070529Dave.
Re: Help identifying a Nardi range cooker
Now it works 🙂
It’s an EK95583 suffixed A or B depending on the age but it’s only cosmetic differences by the looks of it.
Fan element the same for both versions.
Dave.
Re: Help identifying a Nardi range cooker
Your image link doesn’t work unfortunately 🙁
The model will be inside the drop down flap at the bottom and begin with EK…..
Assuming it’s branded Nardi on the control panel and it’s a 90cm range then the fan element is the same for both model types (there are only 2).
If you’d like the element ordered (I can easily obtain for you) an email to spares@ukwhitegoods.co.uk please 🙂
Dave.
Re: hygena cooker hood / extractor – fuse gone?
It may have blown the PCB sadly (model dependent), most won’t have an internal fuse.
The plug could be anywhere to be honest depending on how it was installed.
Dave.
Re: Hoover Slimline D/washer D7276 Door Handle
Connect’s part number 5031681812380 – is that it ?
Dave
