[DDSDDS]

Re: Damaged floor

thanks martin thats exactly what i was hoping to hear i honestly dont think i did it
i think shes just hard up because she didnt even want to get a quote for a replacement she just wanted money towards the damage

[DDSDDS]

Re: COPRESSOR SIZE

would this from connect do it ?
5031683033325

[DDSDDS]

Re: HOTPOINT WD61

a friend of mine in Preston needs a copy of this DiagraM
Revill1982@hotmail.COM

[DDSDDS]

Re: ZWF1270W

any chance I can have the same email please

[DDSDDS]

Re: WMA 64 1600 ULTIMA

thanks for your reply
i came to the same conclusion mysely after much messing around and it was the door lock
wish id seen your reply earlier would have saved me loads of messing lol
thanks

[DDSDDS]

Re: Beko WME7227 WME8227 Laundry Range Carbon/Motor Failure

would love a update to this as got the same fault machine brushes are ok it appears to pump but no motor action

[DDSDDS]

Re: Beko Test Sequence needed

any chance i can have the same test routine pls

[DDSDDS]

Re: MOST EXPENSIVE OVEN THERMOSTAT EVER

the alternative is typically out of stock

[DDSDDS]

Re: wdl 520

wasnt the 680uf i have done enough of those to spot that
wasnt the brushes it was defiantly cured when i tapped the pcb which was out of the machine at the time
have no idea if that is the same fault as you get on the rinse but i have come to the conclusion that these machines are not of very good standard

[DDSDDS]

Re: wdl 520

Got those emails many thanks

Danny

[DDSDDS]

Re: Hotpoint WMS38 not taking conditioner.

seem to remember they can be funny if not level
any blockage in soap box
does everything else work does it heat drain rinse and spin

[DDSDDS]

Re: Hotpoint WMS38 not taking conditioner.

i have a routine for testing the components one by one ie pump heater valves 1 by one but not for testing for taking conditioner
you should be able to check the valves with a meter but i would check that the conditioner bit isnt blocked underneath first

Danny

[DDSDDS]

Re: wdl 520

another update noticed the machine works till the motor is needed then it does not work if i listen to the pcb i hear a click from the relays tapped relays with screwdriver machine now works fine i shall change the relay i assume ones faulty and my bash dislodged something

yes iadom i would love the tech i will pm you my details
thanks for your help and patience lol:D

[DDSDDS]

Re: wdl 520

right thanks i follow you now
going to replace the top board and check the wiring if thats no good then off goes another board to emw
just the link i had said it was the program progression leds that indicated the fault

[DDSDDS]

Re: wdl 520

is there anyway i can upload a video showing this

[Author]

Posts