Forum Replies Created
-
Posts
-
Re: hotpoint WT721/2G module pcb
acs1
bbgs
ge734
the second line could be 8’s or bs also the g could be a 6 ..the writings tiny
hope it helpsRe: click clunk door lock hotpoint
these are my own recons so would ideally like to be able to repair this very common fault myself without sending them to emw as that puts them too expensive to do for me
Re: Hotpoint Ultima WT741 sparking – advice required
if yours says ont he front super silent it is a 3 phase motor so not brushes
if it does not say this then its likely a brushed motor and the brushes have worn
brushes are easy to check and replace and not expensive
it wont be a wire
as stated beforee electric appliance making sparking noises then stop using it till it has been repairedRe: fdl570
thanks for the reply
since posting i have tried it again on the quick wash and it went through but on the normal wash it seems to develop the fault
only fitted ti 3 week agoRe: And the point is…
smart house in town called eureka now thats what i am talking about “sarah beer”
Re: And the point is…
i cant think of a reason to have this at all
is this not just the delay start just fancier a feature that was listed as useless recently by which?Re: zanussi fle1416
heater is fine there is a low resistance on the machine but its not from the motor or heater it seems a bit rusty think its damp and needs drying
as for the error do you know what it says is it heater relay stuck? something like that?Re: zanussi fle1416
no i have just got the lights and was looking for a hint before i started stripping down and messing with it blindly
Re: Candy G0482/1-80 N-3100246709020475
just done same today halfway through 3 flashes funnily enough though i got an intermittant 16 flash did not got earth leak on heater till it was warm….also found that i had an earth leakage on the front displap board i could actually put my test meter on and get an audible beep on continuity test cleaned excess carbon dust off and fitted new heater going like a good one now
