Forum Replies Created
-
Posts
-
Re: Ariston Margherita A1435
you will notice it takes far less water than older machines
perhaps we should have a fact sheet or printable page to hand out to customers about the modern wash process cold fill only less water etc
i am sick of explaining it to people biggest problem is no one believes me and i usually get the comment of well i have had a washer for 20 years and it was not like this before i want one that takes more water and szo it continues
you can only bang your head against a brick wall for so long till it falls downbtw is the ariston working properly now ?
Re: indesit 🙁
sorry martin my mistake it is 25kohms
and it is on my testing bays which are all cold fill pipes only does not even get tepid
certainly could not have a bath in it lolfrostbite
Re: tricity cooker
couldnt say just an old 80’s sorta style box and when he has all the hob grill and oven on it just flicks down the lever marked cooker
little update as well guy has just rung and told me that his cooker switch in the kitchen on his wall no longer has a red light on it so the cooker is totally dead
i told him to wait for the sparky to come and check his box out as i now think it is definatly that
i just want to make sure i am not missing anything and that i am armed with all the relevant infobtw what is the difference between and rcd and an rcbo?
i never heard rcbo b4 or am i being dense: 😳Re: indesit WD12
i think the fault is its an indesit
but that aside does it flash too fast to count all the way through the cycle? and does itactually heat etc
i would say p switch or most likely mod fault
but aint come across it b4Re: Ariston Margherita A1435
is it taking hot water and when it sticks is it
full
partially full
not agitating
seeming to fill forever
and also how long has it been left after cycle was startedRe: Zanussi FLA 1201W – I’ve started….
think a round of applause is in order for a seemingly good job
just leave some work for the poor starving engineers lol 😛Re: Hoover AM120 new pump not working
check the triac on the module line of 3 or 4 i have had faulty pumps damage those triac bob a new one in and hey presto
sometimes :rolls:Re: Hoover AM110
i have had this fault many times and have changed thermisors to no avail
every time the only cure is main pcb board
i would love to know what was actually wrong with the board so i could repair but cannot seem to find fault with it
all i know is to make it heat again change boardRe: black gunk
getting a bit of topic there arnt we would this not be more beneficial to just state what we know about the gunk and the ways in which each instance can be cleared also and thoughs we have to the cause
now boys shake and make up big kiss 😆Re: Zanussi FLA 1201W – I’ve started….
good luck on the bearings but take extreme care not to damage the shaft when taking it out and pushing back in a hammer in the wrong place can ruin it
Re: indesit w161 fault
10=pswitch not sensing correctly
does your machine over or under fill?
and is it definatly ten flashes
