[dunston]

First program anti clockwise sometimes wont select

[dunston]

Serial number 22-117993-07

[dunston]

Thanks Baron

[dunston]

Cheers Dave. we thought it may be the heat pump or the main PCB. Will look into that.

Mark

[dunston]

thanks for the info dave. The machine seems to start working ok now. not heard back from them in over a week. i did go out and check board connections and heater and motor connections. the fault then went away.

[dunston]

I’m going back to look at it this afternoon. see if i can get any info.

[dunston]

i have a feeling the spanner icon is saying there is a fault and i will have to run a diagnostic test to show the error code.

[dunston]

it did the same, after about 10 seconds the spanner icon comes on and machine stops. i checked the filter for blockages.

[dunston]

Thanks for your replies. 76X5214 is rated at 120*C. Its the upper small oven cut out. The lower main oven cut out is rated at 145*C
The 120*C will be OK but if they use the pyro cleaning function it may operate the cut out.

[dunston]

Thanks Dave. The model is DOD438XU1. I ordered the over heat cut out (BNT76X5214) from Connect but its the wrong cut out. Its the top over 120*C cut out I need the lower main oven cut out. I think its rated at 145*C. Do you have any idea of the part number for the lower main over over heat stat?

[dunston]

Late update about this job. Replaced the dual valve and it worked correctly – thanks for your advice.

[dunston]

hmm. i have had problems with earth faults on element on hoover machines before. good shout Dave. we going back out and giving the machine a good check over.

thanks mark

[dunston]

Thanks Jem. That was the fault. Wash motor with a faulty bearing.

[dunston]

cheers dave. i will take a look.

[dunston]

Replacing the Main PCB repaired this fault

[Author]

Posts