Forum Replies Created
-
Posts
-
Re: Removed Thread
I knew I shouldn’t have read that book ” How to be a moderater and make friends” 😆
I think though a 100 w/ms for sale is a bit of a big sell for Classifieds 😕 ❓
Greg
Re: Bosch Upright freezer. Can I fit a light?
Hi
I will need the full model number and the FD number please.Greg
Re: Bosch Hob ignition
Hi Kev
Its more likely going to be an ignition system fault, however as Martin said you will need a gas qualified engineer as his advice didn’t cure 😀
Greg
Re: Bosch classixx 1400 express
amoeba wrote:can someone please confirm what the reading should be on the element
if there’s suppose to be one.Hi
The reading of the element should be appox 30 ohms between its terminals and >10 Mohms between earth and one of the main terminals.
Make sure that there are no wires on the terminals of the heater or a false reading may occur and most importantly, unplug appliance before undertaking any repairs :plug:
GregRe: Bosch fridge-freezer KGE7005/02 compressor fault comand
Hi
On past experience, it is usually the PCB thats is plugged inhorizontally behind top fascia. P/no – 263781.
On a rare occasion you may have a faulty compresser 😥Greg
Re: IKEA Whirlpool Dishwasher DWF-417 error
tomcoady wrote: The pump grinds away for hours but the water never starts to flow.
It sounds to me like the base below the main tank is full of water (if it is the drain pump grinding away continuously) due to overflow or internal leak.
Unplug appliance before investigating :plug:
If you don’t feel confident in attempting repair please feel free to use the engineer link below.Greg
Re: Radio Programmes in Van/or Volvo/or Saab/or unicycle
Some old Irish duffer
Some erm Old Seekers 😆
Greg
Re: At the Movies
Penguin45 wrote:Special Guest appearance from Kev, going
“WHAT THE BLOODY HELL ARE YOU LOT PLAYING AT NOW”Tha knows 😆
Greg
Re: Bosch Dishwasher – Low water pressure in spray arms
andymc wrote:There seemed to be an inner and an outer part of the pump which spin independently (i.e. if I hold the shaft of the motor from the outside I can turn the outer part of the pump from inside the pump
Sorry missed that, I think Penguin 45 is on the money here 😉
Greg
Re: Bosch Dishwasher – Low water pressure in spray arms
Hi
Sounds to me like a weak/damaged re-circulation motor or blockage in that system.
Don’t forget to unplug appliance if you are to investigate further. :plug:Greg
Re: WMA34 Control Board config codes
Hi
Cheers pto that clears that up 😉
Previous post moved here http://www.ukwhitegoods.co.uk/modules.p … 673#103673Greg
Re: Number 2 is watching.
Have removed most of that post and placed it here http://www.ukwhitegoods.co.uk/modules.p … 673#103673 as public forum is not the place to chew the fat 😀
Hope that was okGreg
Re: whirlpool wdp 2440 problem
Hi
Make sure it is emptying ok, if that is ok I would be looking for a crud build up below the filters, around the water indicater (WI) this is situated at the 3 o clock position.
If all clear there, you would be looking at a poor connection to WI,faulty WI or faulty PCB.HTH
Greg
