[gegsy]

Re: TMS

Hi
Sorry for sounding thick but who are TMS?

Thanks

Greg

[gegsy]

Re: Bosch Model No SGS5358GB/17

Hya Boro, thanks for that; was just wondering what more we could offer for a more reliable repair 😉 .

Cheers

Greg

[gegsy]

Re: Bosch Model No SGS5358GB/17

So whats the answer BSH MAN? Replace metering unit and ribbed hose and if really gunged the water matrix??

Greg

[gegsy]

Re: hygena dishwasher

Take photo of control panel and email to dave_conway, he will be able to sort that for you

Greg

[gegsy]

Re: Neff S4453 completely dead.

Check switched spur hasnt been nudged in the off position for eg – cutting up board leaned up against switch and turned it off

Greg

[gegsy]

Re: Guess the sig.

:rotl:

Greg

[gegsy]

Re: bosch wfg2020gb/01

Hi
Worth checking pressure switch operation and NTC
The operating range of the NTC lies between –5 °C
and 103 °C. If a power cut or short–circuit occurs, the
programme runs its course without an error display.
”NTC short–circuit” or ”NTC power cut” is displayed in
the test programme. The NTC is connected to the
heating flange and is sealed with the heater seal.
Before the NTC can be removed, the heater must be
disconnected.
Temperature
in C
Resistance in k
10 8.5 – 10.6
20 5.4 – 6.5
30 3.5 – 4.3
40 2.3 – 2.9
50 1.5 – 1.9
60 1.1 – 1.3
66 0.9 – 1.1
86 0.45 – 0.55

Hope that helps

Greg

[gegsy]

Re: BOSCH WFP 3300 FAULT CODE F01

linrew wrote:

if the machine seems to be filling ok it is possibly a blocked pressure chamber/hose

linrew

Surely that would give you F03 ❓ 😀

Greg

[gegsy]

Re: Diplomat gas oven problem, advice needed.

Agreed, use this link Find Corgi Installer

Greg

[gegsy]

Re: Bosch Model No SGS5358GB/17

Hi
If no water in base, I would suspect module. When you look at 7 seg display when you go; if there is a red dot in the display then definite module.
Remove l/h panel check pressure chamber for crud, also remove lower front and remove 1foot length ribbed hose and clean.

Regards

Greg

[gegsy]

Re: Bosch dishwasher SPS5462GB/19 not heating

Hi agro,
No module in this one just timer and selector unit

Greg

[gegsy]

Re: BOSCH WFP 3300 FAULT CODE F01

Hi
1/ Check you have water coming out of hoses feeding appliance.
2/ Check you havent kinked the fill hose/s
3/ Check for low water pressure feeding appliance.

Regards

Greg

[gegsy]

Re: Am I haunted?

I thank you 😆

[gegsy]

Re: Bosch wfm4030 washing machine heater removal

Unplug appliance first :plug:

Undo nut of heater till its at the end of its travel.Push down on nut and shaft till flush with heater casing.
Then its a matter of teasing heater out with flat scredriver or similar, perseverence Im afraid.

Greg

[gegsy]

Re: Fairy Active Bursts

Was it these Ken?

[Author]

Posts