gegsy

Forum Replies Created

Viewing 15 posts - 5,836 through 5,850 (of 6,724 total)
1 2 3 … 389 390 391 … 447 448 449
  • Author
    Posts
  • February 18, 2006 at 9:30 am in reply to: Bosch WFLI 244O GB Dead #166114
    gegsy
    Participant

    Re: Bosch WFLI 244O GB Dead

    If the machine still full of water? If so drain it down and check for debris inside pump housing. This appliance drains before each cycle and maybe trying do this but pump jammed 😕

    Greg

    February 17, 2006 at 11:41 pm in reply to: Leisure rangemaster 110 #166105
    gegsy
    Participant

    Re: Leisure rangemaster 110

    Just to add as Eastimark said splits in 2. there are screws at rear also. L/H lifts clean off after screws removed (disconnect ignitors) and the R/H slides to the right and off again with strategic screws removed.
    Greg

    February 17, 2006 at 11:37 pm in reply to: Leisure rangemaster 110 #166104
    gegsy
    Participant

    Re: Leisure rangemaster 110

    Hi swerv
    The grill switch will be a different one and should come with a mod diagram as the numbers will be different.

    Greg

    February 16, 2006 at 11:35 pm in reply to: Firenzi DW 930/1 beeping/flashing lights #166037
    gegsy
    Participant

    Re: Firenzi DW 930/1 beeping/flashing lights

    Hi gary
    You will need to look at the heating circuit area.

    Greg

    February 16, 2006 at 7:08 pm in reply to: Whirlpool t/d AWZ650 vibration noise #160097
    gegsy
    Participant

    Re: Whirlpool t/d AWZ650 vibration noise

    Nah I would imagine the gasket (donut shaped) on front right of manifold has snapped p/no 481246688523 😉

    Greg

    February 16, 2006 at 6:58 pm in reply to: Faulty Bosch KGV3120GB/01 #166027
    gegsy
    Participant

    Re: Faulty Bosch KGV3120GB/01

    Fluke wrote:ICould there be a problem with the relay or control board? If the relay was faulty would the compressor kick in when the fridge is turned off and back on again?

    Help appreciated!

    Possible and also its easy to get mod wrong aswell. Would suggest the link below for repairs in all honesty if you find the mod is correct.

    Greg

    February 15, 2006 at 10:19 pm in reply to: Bosch dishwasher SPS5462GB/19 not heating #164451
    gegsy
    Participant

    Re: Bosch dishwasher SPS5462GB/19 not heating

    Erm its not a stat its a microswitch,just works on pressure of water circulating ie not enough water no feed to heater. Stats are situated ontop of heater box.

    Greg

    February 15, 2006 at 10:09 pm in reply to: Bosch dishwasher SPS5462GB/19 not heating #164449
    gegsy
    Participant

    Re: Bosch dishwasher SPS5462GB/19 not heating

    I thank you Mr P
    I would still check the loom and check the pressure system isnt gunged up.
    If you want to check that the microswitch on the heater is activating, disconnect the wires going to it and put your meter on “beep”, under normal re circ you should have a continuity beep thus indicating that the water level is sufficient and that the microswitch hasnt failed (never seen latter EVER) cough LOOM 😉

    Greg

    February 15, 2006 at 9:58 pm in reply to: Bosch dishwasher SPS5462GB/19 not heating #164445
    gegsy
    Participant

    Re: Bosch dishwasher SPS5462GB/19 not heating

    Hi
    You could look for broken wires in the door loom near to where the door bends 😉

    Greg

    February 15, 2006 at 9:55 pm in reply to: Whirlpool awm8163/3 F 07 fault code #164464
    gegsy
    Participant

    Re: Whirlpool awm8163/3 F 07 fault code

    :wave:

    February 15, 2006 at 9:52 pm in reply to: Whirlpool awm8163/3 F 07 fault code #164462
    gegsy
    Participant

    Re: Whirlpool awm8163/3 F 07 fault code

    Hi Martin
    F07 is a problem with either the electronic module or motor ie a drive problem.

    Greg

    February 15, 2006 at 7:32 pm in reply to: Bosch SGS 6312GB #164427
    gegsy
    Participant

    Re: Bosch SGS 6312GB

    In 10 years of Bosch I have never had any of these wash pumps fail.
    What is the symptoms you are getting and FULL model number ie – its either a Gb/04,07,12 or 13.

    Thanks

    Greg

    February 15, 2006 at 7:19 pm in reply to: TDS Disk #164303
    gegsy
    Participant

    Re: TDS Disk

    Cheers for the inputs.
    I removed Adobe 7 and put Adobe 6 in………Voila all happy again.

    Cheers

    Greg

    February 15, 2006 at 10:22 am in reply to: stuck door #164372
    gegsy
    Participant

    Re: stuck door

    Hi
    Model would be a helpful. Seen a few where the fascia has broken around door lock mountings and if unluvky door lock broken aswell.

    Greg

    February 15, 2006 at 10:03 am in reply to: TDS Disk #164301
    gegsy
    Participant

    Re: TDS Disk

    Cheers will do Jim

    Greg

  • Author
    Posts
Viewing 15 posts - 5,836 through 5,850 (of 6,724 total)
1 2 3 … 389 390 391 … 447 448 449