[gegsy]

Re: Whirlpool Dishwasher AFG7560

Suzianna wrote:Thanks very much…will get the wife right on it! 😆

😯 😆

[gegsy]

Re: Whirlpool Dishwasher AFG7560

:waving:
:p45:

[gegsy]

Re: Whirlpool Dishwasher AFG7560

Hi
It may be worth removing the filters and gently cleaning the Water Indicator (round unit with honeycomb effect) at the 3 o clock position in the sump recess, with a toothbrush 😀

Greg

[gegsy]

Re: word to the wise

Maybe some of the luck of the Irish has come back with you and remind me not to park next to you 😉 😀

Greg

[gegsy]

Re: Bosch SMS5012 – Help…..

:waving: :look:

[gegsy]

Re: Bosch SMS5012 – Help…..

Hi Gypsy
Sorry, have a read here http://www.ukwhitegoods.co.uk/modules.p … pic&t=4357 No 7 😉

Greg

[gegsy]

Re: Bosch SMS5012 – Help…..

Hi
First thing I would check with this beast is the black rubber hose from the water matrix on the left to the sump (S shaped)
Remove it and thoroughly rod and clean it, re assemble and test 😀

Its worth checking for broken wires in the door loom also, where the loom pivots at bottom centre of door.

Power off first before attempting any of these :plug:

Greg

[gegsy]

Re: Bosch SKT5002GB/03 – Not heating water….

bargepower wrote:p.s. Gegsy, I use Finish powder and use half the measure as per the Bosch instructions.

Excellent 😀

Greg

[gegsy]

Re: Bosch SKT5002GB/03 – Not heating water….

Hi
These tabletop models aren’t geared to use tablets if thats what you are using, for one they don’t fit and two they are way too much detergent for the little fellow.
If used you will end up with a lot of froth but not enough water to activate safety switch on heater thus giving no heat 😀

Greg

[gegsy]

Re: long cycle times on Bosch S9F1B

Hi
Worth checking the heater, it should read app 20 ohms. Unplug first 😀
Make sure there is sufficient water in tank when washing. The water level should be about half an inch below teh lower spray arm
If its not that high, its worth clearing the clear ribbed transfer tube which runs from the metering unit on the left to the sump. Access is by removing the front lower plinth.
As said before, make sure that there is no way that the drain hose can backfill from where its connected ie sink.

Greg

[gegsy]

Re: Neff U1721 Fan noise

Glad to hear it 😀

Greg

[gegsy]

Re: How to replace main oven light Neff U1422

Hi
The new lamp holders are coming with a new lense cover c/w metal collar to alleviate this jamming problem 😀

Greg

[gegsy]

Re: Bosch WFT2800

Blimey, it has to drain during the wash cycle and prior to rinse 😯
If it isn’t its going to be as Martin suggested IMO
Too hot during wash so defective pump jamming, as it gets closer to the rinse cycle it appears to cool sufficiently to allow the pump operate and continue onto cold rinses with no problem 😀

You will need full model number off appliance and what make of pump is fitted ie – askoll or siemens as it could be either 😉

Greg

[gegsy]

Re: Bosch micowave F8 fault

bubs wrote:Where is the spell-check on the subject line?? 😳

Sorted 😉

E8 is problem with the inverter board not activating.
I would remove the magnatron and check that the permamagnet isn’t cracked and also its resistence failing that its most probably the inverter board itself 😀
Make sure that the installation ventilation is as per tech sheet as they need more than a usual single oven 😉

Greg

[gegsy]

Re: Neff U1721 Fan noise

Hi
Fan probably not far enough down the shaft.
Remove the fan, get some WD40 or equivalent onto shaft and then offer it back on.
Dry off residue
Should slide smoothly until it stops.

HTH
Greg

[Author]

Posts