Forum Replies Created
-
Posts
-
Re: Diplomat ADP8234
Hi
Copied this from another post which was answered by Penguin45:-
[i]You are in the test programme somehow. To exit, switch on, wait three seconds and press the programme button twice, quickly. Switch off, switch back on and it should be OK.
Regards,
Penguin45.I hope this helps
Geoff
Re: Lamona Dishwasher HAJ8631
Ah
Thank you for that. learning something new every day.
File sent
Geoff
Re: Belling oven
HM
Cream could be EGO or Diamond H. Cannot remember what the other one is.
But if you can get the numbers of them and either onto connect site or google it should come up with what you need.
Geoff
Re: Belling oven
Hi
Could be a 6060 model but with regulators the best thing is to get the numbers off them which will help to identify it.
Would not be surprised if this was a blue regulator made by Invensys mp-vo1-svc part number 082590800 but do not take this as gospel.
Hope this helps
Geoff
Re: Lamona Dishwasher HAJ8631
Hi Taff
Have you an email address so I can sent some stuff over?
Geoff
Re: Beko DW601 – burnt out float switch
Hi
Check the diverter valve just above the float switch. I have had about 3 leak water directly onto the switch causing it to burn out like this.
Hth
Geoff
Re: Samsung WF1124XAC/EU
Bump
Can any one help
Suspect that part number DC92-00969a may have superseded original but can someone confirm this for me
Many thanks
Geoff
Re: Hotpoint WMUD962 – no fill
Hi
I had same problem on a WMUD10637. After speaking to Hotpoint I was told to start programme as normal and it could take up to one hour to start filling.
Suspicious or what but tried it.
Returned after about 40mins to find the water level approaching the soap draw!!
Drained machine and started cycle again and it worked ok stopping at correct levels.
This is the only one I have had ( watch out tomorrow) which again was after blockage. Had no problems when doing drum changes etc.Geoff
Re: Lamona LAM8601 Int’ D/W constantly draining
Hi
make sure that it has done reset ( hold button in for 3 seconds and wait while it pumps until ready light comes on – could take up to 1min).
If ready light is lit then it is suspect to be module 1784050130 or float switch 1883240100 as the module and switch both provide neutral for pump.
GeoffRe: Hotpoint WD62
Hi Jim
I will check when I go back as I only checked coil and did not think of magnet.
Geoff
Re: Hotpoint WD62
Hi Andy
I checked there and pulled plugs off at both ends to test cables which were OK
Geoff
