Forum Replies Created
-
Posts
-
Re: Zanussi DE6754
Ah
Got beaten to it with manuel.
Check for burnt mark/dry joint on pcb where heater is fed from. I think from memory it is the second contact in from the end. These modules had a problem for this at one time and machine would sit in wash mode waiting for water to heat up. You could check the rest of the heater circuit but try there first
Geoff
Re: Zanussi ZJ1218 E30
Have sent some information over on email for you.
Pretty large email but will give you plenty of bedtime reading
Geoff
whoops just saw the bit about switch – yes it should be attached to cross member just to the right of mains terminal block looking from the front
Re: Zanussi ZJ1218 E30
Johnny
You would need to go into service mode to find out what the true code is.E30 is just displayed for user. in service mode code wouth be e31 to e39 which are all different faults.
which pressure switch did you change as it has two. Large one which realy only controls power to heater and there is one fitted under cross member.
Do you have details on how to access service mode?
Geoff
Re: Zanussi TDS382W dryer. How many bearing pads?
Hi
2 bearing pads at top from the information I have.
Some of the bulletins I have emailed to you this morning
Geoff
Re: Diplomat APM6855 F/Freezer fan motor
Hi
I should have one that I ordered earlier this year part number servis 512021000 or connect 5045171056666.
Got caught thinking it was open circuit thus faulty which it was not. Fan only comes on when door closed.
The duct on mine kept icing up which I could not cure.If you are still looking for a motor then let me Know
Geoff
Re: creda 48196 grill element
Hi Mike
Try C00233740 which I have taken from the 48190 model. It may be the one you are looking for
Geoff
Re: Whirlpool AWM8000/1
Sorry Helo you have lost me a bit there.
Are you saying that the machine has a module fault?
No to excessive amount of water in unit
Contact after sales service? Customer has contacted myself as Whirlpool do not have servicing arrangements for this area.
Does anyone have any form of service information of this appliance
Geoff
Re: Asko fridge freezer KN8526
Dont know if this will help
Part number 33213101 and is shown on connect but as obsolete.
Electricalsales.co.uk is where i obtained the part number and are advertising at £25 but do not state if it is in stock
Geoff
Re: Diplomat/Whirlpool ADP8332
Hi
Thank you for advice. will go for user board as only one fitted
Geoff
Re: Miele T5213
Hi
Yes it is the commercial one with the heater on left hand side.Have checked all 4 ( 3 are resetable) and the one fitted to the duct on the front.
Wired to 240volt but looks to me as if the 3 heaters are wired in paralell from the relay.
You could be right about relay or what controls it as it appears not to activate.
Again thank you for your advice and help
Geoff
Re: Miele T5213
Hi
No not even the plastic pouch it normally sits in on the panel is there.
Suspect someone has been there before me.
Geoff
Re: zanussi de4554s 911788041 wash pump
Hi
Have been on pro corner and they are listing 50296187003 as equiv to the part number you have quoted. Cannot not find this on any sites like Connect or Masterpart but distri do say that they have in stock ( expensive)
Many be worth giving Distri parts a ring or checkin on aeg-electrolux.co.uk site to confirm
Geoff
