Forum Replies Created
-
Posts
-
Re: AEG Lavatherm 57800 code
(E21) pump triac faulty on main board, or (E22)sensing triac faulty, again on main board. It may also be worth checking out the pump
Re: Electrolux EWX14440W integrated washer dryer wont start.
Configured board is available for this 973914602300001
Re: bfi620 flashing 1&3
What was the outcome on this ❗ I have one to go and see later with similar problem
Re: AEG T57560 Tumble Dryer
Re previous reply:
Always unplug the appliance from the electricity supply before carrying out any inspection or repairRe: fs1255
Re: previous reply:
Always isolate from electricity supply before carrying out any repair or in spection of an applianceRe: AEG T57560 Tumble Dryer
It has been found that in a large number of cases this may be caused by fluff building up inside the dryer reducing air flow which causes the element to overheat. Check for fluff on the front and rear seals which can cause the drum to rotate more slowly. This slows the hot air fan and reduces airflow over the element. Failure to clean the condensor frequently and the ducts around the door opening are another possible cause. Other causes:poor ventilation;Thermostat and sticking heater relay. On one occasion lost supply to the motor from the main board after running for quite some time.. I hope this helps
Re: Zanussi frost free ZENB2925S
Hi,
This appliance needs to be situated in a room with ambient of min 16c – max 32c.They are doing exactly as said in the instruction manual for each of these appliances. Manual selection of spin is required on delicate programmes
Re: aeg e10 fault ???
e10 on this appliance unlike most aeg/electrolux group appliance relates to a no drain problem during wash. programme is paused and you need to check the usual/relevant parts.
