Forum Replies Created
-
Posts
-
Re: CDA CW494
the serial number **04 ****** **** is the year and
**** 24**** **** is the week number it was made.Re: whirlpool cooker fault 03
most of the time the old board can be configured and it usually works, you may have a new faulty board if it keeps flashing stop every so often. Its not a wiring fault, i had this before and spoke to tech, they said replace board again.
Re: whirlpool cooker fault 03
put the old board back on it and cut out resistors 2 and 3
[color=red]remember they go 0 1 2 3 4[/color]not 1234
Re: whirlpool cooker fault 03
tell me what number is after the model (service number) and ill let you know. 😮
Re: whirlpool cooker fault 03
before you order the new board, cut the resistors first, this works 90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time!
Re: Whirlpool American side by side, 2 dashes in display
Seamy wrote:She said its showing — two dashes and alarm sounding. When she resets alarm it will go for a while & show -18 and 5c. But will alarm again after a few hours.
I advised her to contact Whirlpool for repairs as i don’t do Refrig’ work, just fit the odd t’stat.
good call! 🙂Re: Diplomat ADP8322 tripping RCD
Claire71 wrote:I don’t think the motor started. Some water went into the machine before it ‘tripped’, but I don’t think it got to any actual moving around of the water. Is it worth getting it out and drying out the base as suggested in some other posts? Could the blocked up drain pipe have caused damage to the pump? It’s almost two years old – do you think it’s worth repairing one of these seemingly bad dishwashers? I think it’s around the £100 mark for a new pump isn’t it? Thanks again.
I’ve had a machine before where the drain hose has ben blocked, the water indicater was clogged and it started to fill and the water flooded out of the door before.Its not very likely that a blockage caused damagae to the pump. the wash pump is around £92.
A new machine will cost you inbetween £350 – £450, so its probably worth having it repaired.
Re: CDA CW494
linrew wrote:hi
these machines usually come with a 5 year warranty, it may be worth contacting CDA to discuss a repair (labour costs) if it less than 5 years old
linrew
I didn’t realish they came with a 5 year GT. Call out your local service agent then and get it done properly 😛Re: Matsui MCE 60TC
you need to stick the foam to the worktop around the hole you have cut out for the hob – DO NOT SILICONE IT!!!!
Not to sure about the model your dealing with, but normally the clips attatch to the hob so you can push the hob down, put cant pull it up.
careful when doing this because if your worktop is chipboard, it damages VERY easily! and getting it out with the clips on is difficult to, so be careful!!Re: Fisher & Paykel Dishwasher 292T
I think you may have water in the base of the appliance, the few ive worked on the lid motors are the main culprit for leaks on these appliances, or possibly something stopping the lid closing down, like a plate thts to big or something similar. If you pull out the bottom drawer and unclip the runners (each side of the drawerat the bottom behind the front panal) and see if there is water flooded.
If there has it may have blowen the power board under the plastic cover.
!!!If you do decide to check TURN THE POWER OFF!!!Re: CDA CW494
when you open the door, count the flashes between the pauses and that will give you a fault code, let me know how many times it flashes and ill tell you 🙂
It could possibly be an NTC fault or a control board fault on the heater circuit.Re: Miele Premier 520
Gromit9084 wrote:I have recently purchase a Miele Premier 520 and it is not cleaning correctly. An engineer has checked the machine and found no faults. Has anyone got an idea of what the problem may be as this in not what i would expect from a Miele.
when you say its not cleaning properly, in what way is it not cleaning, it could be a variety of things.
What things are you trying to wash and on what setting are you washing them?
Did you do a service wash before you used the machine? (run it on 95 degree wash)have you loeft enough gap at the top of the drum, the machine should only be 3/4 full, or it will have poor wash results.
Re: Radio Programmes in Van/or Volvo/or Saab/or unicycle
effzedarr wrote:Awww been there, grown the Mullet 😳 , now got a sensible haircut before gravity kicks in & removes it for good 😉 ! Plus as you get older yer music taste get wider,aswell as yer waste line 😆 . Good to see i’ve got a Mark & Lard fan on board!!!!
Who is this Richard Allinson standing in for Wrighty? Loves his own voice too much for me,lets have Mark Radcliffe back!!!!!!!
Chris..
BRING BACK MARK AND LARD!somebody should start a petitian, Colin and Edith were OK but now Colins gone as well, its all going down hill!
