[kjmac1980]

Re: Whirlpool wont spin

cheers greg
i’ll check the pins, the wires seemed fine (no breaks) but that was just a quick check.
thanks again
kevin

[kjmac1980]

Re: jmb wiring diagrams

read and understood m8 thanks anyhow 🙂

[kjmac1980]

Re: Indesit W143

the fault code is indicated by however many times the on/off led flashes usualy flashes once followed by a pause for a second then again etc once it has reached its diagnosis there will be a pause for maybe 3-4 seconds then it will repeat the sequence(and the timer knob will also be clicking round) i think the most they flash is 13times but could be more dependig on the fault.

hope this helps
kev

[kjmac1980]

Re: Bosch WTL 5500GB Condenser Dryer

could be the motor supressor (think thats what its called) if this not working then your drum wont rotate. the motor usually drives a condnser fan and if this not turning then that could explain condensation build up.
if its been doing this for a while then it could have easily damaged the pcb inside
hope this helps
kev

[kjmac1980]

Re: hotpoint wma 76 🙁

brushes are ok m8 recently changed them, thought it might be a pcb problem so took the main fascia pcb and the one from the bottom of the machine to qer for testing this afternoon if no fault found i’ll try the motor tomorrow. thanks again
kev

[kjmac1980]

Re: Hoover Ecologic Washer Drier Flooding Problem

hi ian just stumbled upon your problem, have you tried changing your cold inlet valve? i have found this to cause a problem but mainly on a main wash. hope this helps
kevin. 😀

[kjmac1980]

Re: wm73 – E15-Heating element

would like to thank iadom for the above info. only joined this site today and found an answer to a problem within 5 mins.
keep up the good work fella 8)

[Author]

Posts