[kwatt]

The tab … ^^^^^…. up there that says, Latest Activity on the homepage of the forum. 😉

K.

[kwatt]

AEG and Zanussi are both Electrolux Group products and it is almost for sure that many components will be shared.

Think on it like the VW Group, lots of brands, lots of models, lots of bits from the same parts bins.

K.

[kwatt]

Error 2:

The Water Fill Phase was not completed within the designed limit time.
Defective Solenoid Valve, Pressostat, Water Fill Hose, Low Water Pressure in the network and/or Wiring.

K.

[kwatt]

Hi,

For anyone to help they will need the model and preferably the serial number to look up the machine and see what fault code set it uses.

K.

[kwatt]

Hi Jane,

Normally those are accessed from the rear, they’re not that hard to swap out it’s just the getting to them that’s the hard part. Mostly though it’s back panel off and all will become obvious,

K.

[kwatt]

Martin provided the info for this sometime back, might help you:

Bosch Washing Machine Stops At 1 Minute

K.

[kwatt]

It is probably a faulty switch/PCB unit, this one:

http://shop.ukwhitegoods.co.uk/w0000051-cooker-extractor-hood-switch-pcb

Can’t guarantee it but, odds-on favourite that it will be that.

K.

[kwatt]

Ta, we’ll see how it goes.

K.

[kwatt]

I’ve got Sudeep looking at a mod for the forum that allows us a one-click ban!

Essentially that means it’s one button and all posts, PM’s and the user are all zapped in a single click. Useful for the bots etc.

K.

[kwatt]

Bosch Siemens Haustergate.

Bosch basically who owns Neff though for this you’ll need to call Neff.

K.

[kwatt]

We are looking at it, there’s a limitation on the search in that, it has to be four characters or more so as you don’t the like of “the”, “and”, “for” etc affecting the search return as you’d then get bombarded with inaccurate results.

But, in this industry, of course, there are loads of three digit error codes.

So all this = a quandary!

K.

[kwatt]

To look up anything any of the guys will need the full model or ENR number off the rating plate that should be around the oven door opening.

K.

[kwatt]

Possibly. Possibly the compressor not pumping as it should and again, possibly the board.

My advice though is not to throw money at it as most parts are obsolete for it now so it’s at the end of its useful life in any event.

K.

[kwatt]

There are many possibilities not least of which would be the main board or compressor. Is anything running at all?

K.

[kwatt]

It does seem to ignore stuff that is too short or, you get slews of results including partials.

I will ask and see if there’s anything that we can do with it.

K.

[Author]

Posts