Forum Replies Created
-
Posts
-
Re: Lamona Washing machine
When you look at Lamona customer services, it shows a GDHA. So Glen Dimplex
Re: zanussi washing machine ZWF16581W FAULT CODE EF2
took all hoses off, all clear and filter clear as well, no fault found. could it be a board issue? not familliar with modern day zanussi’s. we’re mainly trapped in hotpoint/indesit,bosch warranty work.
thanks again
Re: hobart dishwasher chf 40
if this is one of the new hobart dishwashers, the dishwasher will not work unless the filter and cover is in place in the tub. there is a magnet in filter cover to activate the reed switch, check incase the magnet has fallen out or is missing? good luck. cheers.
Re: Zanussie ZWX1605W stops during wash and rinses
Check pump by substituition if reqd as have just done so on ZWX1606W. Pump was failing intermittently during wash/rinse. Couldnt seem to catch it in the act but finally did. On bench would fail to start three out of every ten times.
Ron
Re: Hoover HDV6 capacitor
Thanks for the replies. Will take an 8uf along.
When it stops the timer can still be heard ticking away so mains supply problem was eliminated early on before the substitutions. Should have said that 😳
Was convinced this was relay fault. Its a vented job this one.Thanks again
RonRe: Creda dryer getting too hot?
this is just random, but u didnt put a 7mF capacitor is the newly modified ISKRA 351 motor instead of an 8mf?
cheers
Re: Indesit Domed Torx Pulley Bolts
whack the bolt a few times with a mallet, ensure the there is no movement in the pulley after locking it, remove with an impact T40 bit, works a charm. no fuss
ps. dont weaken your bit by over stressing it when tightening the bolt back up again!
Re: Independent Services (DA) Ltd
agree with Mac, parts can be problem. a lot of paperwork as well tho 😯 . otherwise spot on
Re: Hotpoint WF220 is not very good at all
you checked the sump for foreign objects ie, colour catchers? :rolls:
Re: Servis caress 1300 – M3103A washine machine no fill, no
you have not indicated any motor action. on some servis machines,the drum agitates as it fills and if the motor goes open circuit you will get the problem you are describing. go for option 1, get a proffessional in for an inspection,ensure you ask for a quote first tho!!! cheers
Re: Blomberg EOD609SS/1 Part No required pls
Can i have one more crack at this request?
Require the ROUND cut out situated out at rear of TOP oven. Marked 36TH21
l220-40C
Blomberg EOD609SS/1
Need Pt no pleaseThanks
:bang:
